5 Painters in Gregory Hills

Hi, I need someone who can ideally do all of the following: - removal of fence posts, will need to be dug out in some instances and some posts have cement on bottom of them, and then removed from site - stabilization of front fence, would need to see this one (it's a maybe) - squaring of front hedge (straighten top), small section of hedge - Guerney to all exterior of house to remove dust, dirt and any cobwebs - paint touch up - small touch up and colour match to patch on wall inside (about 50c size) and paint touch up to exterior timber on upstairs balcony which may need sanding back, then undercoat and paint - a few small areas

Need to clean, sand and re-oil outdoor timber feature deck. Current deck has been oiled with water based decking oil, but is peeling due to sunlight exposure and needs to be re-applied. Deck consists of 3 steps 1100x2740mm each in size down to brick veneer mailbox. Decking is 90x18mm Merbau hardwood. Deck needs to be stripped clean, then belt sanded. Then re-oiled with 2 -3 coats. Decking oil will be supplied.

I will need a plaster to finish if some new walls and joins made in qyorock walls

Paint a kids bedroom. Diagonal lines on one wall to make 3 different colored sections.

In Gregory Hills Sydney. Needs to be completed by Friday 28/7/17. Painting 2 coats of Undercoat to office space with walls that are around 60m wide in total and 2.6m high. So around 180sqm in total. This job includes protecting ceiling, floor, electrical switches (around 4 of these) with masking/painting tape to avoid getting paint on them and removing the tape after the 2nd coat. Paint, Tape, 230mm roller and 2 paint brushes will be supplied, but ladder and drop sheets to be supplied by person doing the job.

We are after someone to come to paint a few areas in our house - aprox 15-20m2 to paint from existing white to grey with the glitter as the final coat

Ceiling of pergola is finished and fixed. We have tried multiple times using different methods but not happy with finish of joints. Just need someone who can achieve a smooth seamless finish on the joints using putty, plaster, sanding back or whatever to get the finish we are looking for. Also requried to fit wooden border to edges using mitre joint. (Supplied by me). Ceiling hight is 2.7m Area is 4.5mx5m I will supply paint and roller and i have cheap ozito sander and drywall sander too. The job would be much quicker if you have your own quality tools and skills to match.

Need to Put the Walk Papers in the New House