20 Internal Door Installers in Adelaide

To install double hinged doors in an existing bifold frame

Bedroom door damaged, looking for cheapest replacement possible. Plain white hollow.

I need two standard size internal doors replaced (doors already purchased) and the old handles swapped over.

Requires chiseling for hinges and handle mechanism into the architrave and approx 20mm taken off the bottom of the door to account for floorboards that have been installed

I would like someone to hang 5 internal doors.

I need a welder to weld some internal doors for me. I have the measurements etc of what I am after. Prefer to pay an hourly rate.

Fit new door into existing frame. I can supply door, hinges and handle, or we can discuss what is needed and you supply it all.

House has 3 sliding doors fitted want go back to original fitted hinged doors.

I want to have this door open the other way, so it will need to be hung from hinges on the other side. The door/house is very old so it may not be a straightforward task of just flipping the door.

At the direction of a handyman, I purchased a pre hung door from bunnings, which he was going to install. However he has said he's no longer available. He was also misleading in what was required and the cost. I need it done, but need someone to have a look at what else may need to be purchased to complete the job as well. I need it to be done well, but without being overcharged for a small simple job. I'm located near Campbelltown. Date required as soon as possible, depending on quote.

I need 1 hollow internal door hung and the handle put on. I have old door to use as a template if needed. No painting required. I have the door and handle ready to go.

We need 6 unpainted internal doors with hinges supplied and installed (we have already purchased door handles). We need the door frame to be adjusted on the toilet door as it used to swing inward but now swings outward. We are in Magill and the house has standard height ceilings. Our house is double brick and was built in 1965.

Hey there, Have two internal doors (hollow core doors) to be hung. One is 800mm wide, the other 700mm. Door 1: The frame has the hinges already affixed to the frame. This door will not need a handle installed (it already has a handle). The other door - has a steel frame but without any hinges - the hinges will need to be riveted to the frame. This door will need a handle installed. Both doors will need the bottoms cut with a circular saw and the sides planed to fit the frame. Tasker will need a plane, circular saw, chisels, drill, as a minimum. Would prefer someone with an electric plane and a router. I will supply the hinges, screws, handles, the doors. Pretty standard door hanging job aside from one of the doors needing to have the hinges riveted to the steel frame. Thanks

replace three internal door handles, fix sliding door and put up four hooks for hanging pictures. I have three internal doors that need door handles replaced, I have the door handles. fix a sliding door and put four hooks in place to hang pictures