Book a professional blind repair service in Sydney Eastern Suburbs

I have a 20-year-old manual Luxaflex Silhouette blind. The continuous cord loop snapped and has been pulled out of the headrail. I need an experienced specialist to: 1. Supply and re-thread a new manual cord loop. 2. Ensure the internal manual clutch is working correctly. 3. Re-attach to the existing wall tensioner. We had a tradesman came over and glued the ends of the cord back on, but it has recently snapped again. We are wondering if you would still be available to supply and replace the snapped cord?

I have a 20-year-old manual Luxaflex Silhouette blind. The continuous cord loop snapped and has been pulled out of the headrail. I need an experienced specialist to: 1. Supply and re-thread a new manual cord loop. 2. Ensure the internal manual clutch is working correctly. 3. Re-attach to the existing wall tensioner. Must have experience with Luxaflex/Silhouette sheer blinds specifically. I have attached photos of the headrail and the broken cord.

1. drill holes in ceiling and install 4 brackets for 3 dual roller blinds 2. install the roller blinds

Old shutter blinds need to be removed and new blinds installed. I do not own a drill so will need to have your own.

I need one IKEA FRIDANS roller blind installed above a window in my apartment in Paddington. IKEA FRIDANS Blind and mounting brackets are supplied. Installation is into a brick wall. Installer will need their own hammer drill, masonry drill bit, level and any spare wall plugs/screws just in case they might be required. Looking for a neat, level installation. Please quote including all labour and any small fixings required. Visitor parking available.

The automatic blind on our Velux skylight has stopped working and I would like to have it fixed

Hang 3 new roller blinds - you’ll need your own ladder

One of the blinds has fallen and I need it to be put back into place. I.e assembled back into the slot it belongs in.

Hi! I've got a single roller blind that's stopped working and needs the chain clutch mechanism repaired or replaced. What's happened: The blind was let down too far past its limit at some point (before I moved in), and the chain connector bead has jammed up into the clutch and mangled it. There's no chain stopper fitted to prevent this, which is likely why it happened. What I've tried: I've pulled the clutch out and inspected it. The chain loop is seated and oriented the same way as the working blinds, but it now only drives in one direction — it lowers fine but locks like a seatbelt when I try to raise it, no matter how I set up the loop. I'm fairly confident the clutch is internally damaged and needs replacing rather than just reseating. What I need: - Replace the roller clutch / control unit (please bring a spare to suit a standard roller tube — I'll attach photos so you can match the size and bead chain, looks like a standard ~4.5mm bead) - Fit a chain stopper / limit stop so this can't happen again - Re-roll the fabric onto the tube if it's slipped at the end, and test it raises and lowers smoothly Helpful to know: There's an identical blind right next to it that works perfectly, so you can match the setup exactly. I'll attach photos of the broken clutch, the working one, and the bracket. Timing: Looking to get this done today, tomorrow, or over the weekend. Please bring the part with you if you can.

There are two veneitan blinds in a one bedroom flat that need replacing over the weekend or on Monday or Tuesday. Remove 2 x older venetians and install these new shown in the photo. Must have done this before and have own tools. It's been measured to go into the existing clips but we want to unscrew the old and replace with the new clips.

Remove the old blinds drilled into the wall (please note that that the wall is brick/concrete) and install IKEA wall mounted track rails. There are 3 which which comes to 420cm across, but total size will need to be cut down to 400cm

Outdoor blind (auto rolls down) on a window in apartment. Stuck half way down Will need extended ladder to get it from side of apartment (2 floors up)

3 bedroom windows. 1 hallway window. 1 kitchen window. One loungeroom window and a sliding door in loungeroom please.

We have blinds and s fold curtains that need installing. Looking for someone who has done this before and has the tools. We have seven blinds in total and one two-track s fold curtain.

Hi, my large translucent roller blind in Bondi Junction is not able to be rolled down. I think part of the material is stuck in the roller mechanism. The blind is only a few years old. I need a very experienced blind installer to come and fix the issue. If they cannot, I would like them to put the repair cost towards a new blind and installation. I'm available tomorrow on Thursday at 3 pm - 4.15 pm or Friday at 12 noon or from 2.45 pm.

3 x jobs , 2 at Coogee and 1 in Bronte Coogee 2 x blinds into timber Coogee 4 x blinds into Aluminium Bronte 5 x blinds into Aluminium

I’m seeking someone to install three sets of curtains from 5 minute blinds. Installation instructions - https://youtu.be/T39pdQmX4ps?si=5QUXEs9fpACg5pqP They are all full length curtains. One is 3300mm wide and the others are around 3000 and 2500. Hoping to get this done tomorrow. 😊

Put up one set of roller blinds above the window

Airbnb property, Need a handyman to fix a broken blind bracket. Plus a dry wall small hole

Remove blinds and brackets for balcony door. Due to my work schedule I am only available on weekends after 12pm or weekdays after 4pm. Thanks.