Book a professional blind repair service in Paddington NSW

The blind fixture has come out of the wall, and needs to be secured again, the bracket and screws were found (pictured).

The blind chain snapped and I can’t re-attach it. Need it replaced and re-threaded.

Need 3 simple Bunnings rollar blinds installed and drill needed

Install brackets for vertical blind - small window

Electric blind needing re fitted, blind has came off, need someone to dismantle the pole above and rebind the blind on

4 roller blinds need cleaning

Handyman needed to install Venetian Blinds (x1) :: Simple face installation, blinds come with all pieces. Installer must have driller. I have a tall ladder on site , no need to bring one. Easy street parking avallable.

Need assistant putting blind up, drill into brick, above window and take old blind down Need the brick stopper things for the nails Have drill and ladder

Curtain and blind installation Total of 3 rods (two mitred) Hanging of 3 total curtains (2 sheers and 1 lined) 1 x roller 2 x romans I have another guy to help who is familar with the job and measured it, he needs assistance due to injury.

My roll down blinds are broken as the chain has detached from the rod

My out door motorised blind has broken. I believe it needs to be re-strung. It will not go up and down anymore... the Venetian slats do still move.

Need a faux wooden slat blind installed. 63mm size

Handy person required to install three window blinds. Must have own tools, small ladder can be provided.

Replace a frayed cord on a small Venetian Blind. I will buy the cord. It would best be done on site.

The blind is holding by a thread. I anticipate that it will require a total re string. It wasn’t an expensive blind so likely cheap thread used which has become thread bare with repeated use.

Large motorised blind needs to be reduced in width to fit new window. I have all the measurements and parts.

I have a few projects that require works in the blind / curtain department One house requires all new blinds/shears and would need proper quoting based on materials Another property requires slight customisation. We want the outside of these blinds to read as green, the same colour of the building. So would need to stitch on green fabric at the back of the curtain / blinds

I need to have to install one roller blind. The old brackets need to be taken out - they were nailed in and the new ones to replace. It is the windoware range from Bunnings so relatively simple installation I just don’t have the tools

Supply and install two white blinds on internal windows 158 x 90 146 x 56

I have purchased 2 roller blinds (150cm wide and 180cm wide) and need the brackets screwed into the wall/window. It’s a simple job - 4 brackets to screw into a brick/cement rendered wall, plus 2 chain catches