Find a professional gate installation in West Melbourne

I need the following done: - replace entrance gate with another manual gate. - replace driveway gate with another manual gate - install wooden fence with sleeper (total height would be 1.9m) - remove a small bit of the fence I have the gates that need to be replaced. Additional details are in the pictures

I had a colorbond fence that fell due to high winds. I was hoping to have it replaced with a gate. The gap is approximately 1m or just over. Could we use some of the existing fence material ?

Replace 2 blockout blinds 1 in the kitchen living area and 1 in the bathroom. Both have broken chains and signs of wear.Take the 2 damaged ones away to dispose. To Repair the gate post against the brick wall as it wasn't installed properly and its falling down and gate not working.

I had someone remove my neighbours side gate/fence during construction of my home. Now needing it reinstalled. All items remained ready for installation. The bracket will need to be removed and move slightly back to align with new garage wall. Location - Mt Atkinson, Truganina. Need job done asap.

- build side gate where current white door is placed (purchase of materials can be worked out) - take off exisiting maroon door from garage and replace with white door (pictured) - put on wardrobe door handles with handles pictured - install door handles (change latch from round to rectangle)

I need help repairing and reinforcing my wooden side gate to make it more secure. 1. Repair: • There’s a small hole at the bottom of the gate (highlighted in yellow in the photo). • I’ve temporarily covered it with a small plank from behind, but I’d like it properly fixed and made weatherproof. I have got 5-6 full size extra planks with me. 2. Security Reinforcement: • Install metal spikes or anti-climb strips on top of the gate to deter intruders. • Add a diagonal brace (Z-brace) to stop the wood from flexing or sagging. • Optionally, install a metal reinforcement bar or strip to make the gate more resistant to being kicked in. • Check for any weak spots around the posts or hinges — reinforce them with concrete or post supports if needed. I’ve already installed a motion sensor and security camera — this job is to complete the physical reinforcement and ensure the gate is solid, secure, and durable. Location: Point Cook

I have a cross shape drive on one side. Fill the cross with concrete and make 3 steps beside this filling.

Need a handy man to do the below - remove the clothes line from side of house and put it at rear - attach a gate to side of house (gate will be provided) - Repair a crack in the wall

I need help replacing privacy locks for 4 internal doors — all locks are from Bunnings and ready for installation. Additionally, the side gate lock for the fence (also from Bunnings) needs to be fixed or replaced. Some drilling might be required on the gate, as the existing holes may not align with the new lock.

Need someone to supply and install a double sided lockable private gate latch (similar to the picture attached). Furthermore, the screws from the left pillar have come loose so need them tightened and secured to the wall.

Fix the side entry door hinge and lock

Need to remove a colorbond gate at my house.

Gate was recently installed and it has not managed with the winds. Hinge is bent, additional hinge needs to be added to support weight, gates need to be moved down as they are too far above the ground, concrete and pipe added to ground. The ground pin is good into dirt. Happy to hear any other recommendations to strengthen the gate to handle the wind.

-Garage door/handle lock doesn't appear to lock -Side gate/fence appears to be broken and/or a panel missing -Ensuite bathroom basin sink tap is loose ( left side basin )

Setup box so gate can open and close with remote

1. Colourbond Gate needs to be re attached to brickwork 2. Gate latch needs to be re aligned

New gate lock required and door seal re-attached as per the photo Small amout of caulking required between tiles and door jam and kitchen sink to close off the gaps. Price to include supply and install of gate lock.

The front gate is damaged and is in need of repair.

Need below 2 external power points for future gate and water feature. 1. Front of the Home. There is external GPO in the facade- take line from that to until the front (6m) -  see photo 2. Backyard - There is external GPO- take line from that to until the Fence (6m) -  see photo There are trenches already 600mm deep. you may need to correct in some places a little bit. See photo Follow the electrical guidelines to comply with regulation and provide compliance certificate. Once work is complete put back the soil and tidy up. With Regards, Prabu

External security gate not closing- latch is abit far off from the strike plate z may need alignment too.