Find an experienced gas fitter in South East Melbourne

Looking for someone to can do gas disconnection All your job will be gas disconnection only . Gas stove will be lifted by my self . Looking for someone for just gas connection only of course negotiable

The main burner on my gas cooktop has suddenly stopped working properly. It ignites while I’m holding the knob in, but as soon as I release the knob the flame goes out. The other burners are working normally. Looking for a licensed gas fitter (or licensed plumber with gas fitting endorsement) to diagnose and repair the issue. I suspect it may be the thermocouple or flame failure device, but I’d like it properly assessed. Please provide your licence details, availability, and a quote.

The middle gas on the cooktop is not working so it need repair

Converting from all gas to a gas and electric hybrid stove. Need the gas hose fitted and also a small portion of the wood to be cut to fit the new stove size. Already got the electric side sorted.

I'm looking for a licensed and insured plumber to disconnect an old BBQ from its gas connection and safely cap the gas pipe, as it is no longer in use.

I currently have a very old electric cook top. I 2ant to replace it with gas cook top. I have a gas connection for gas heating. The house is on stumps and the gas pipe can easily be extended to the kitchen with just cost of pipe. I am flexible with time but want it finished on the same day. I can forward images if required

Need to add sink outlet and gas inlet for extended kitchen for partial build pergola

Disconnect gas supply from a standard alone gas stove sitting in garage

I have two Bosch gas cooktops, both having a wok ignition head in fault. The first one is Bosch PCR9A5B90A/01. It sparks well but the old ignition head ceramic has cracked. The second one is Bosch PCR915B91A/40. The centre wok burner has no ignition spark, while the other four burners spark normally. I already got both the replacement parts from the official store. Need a gas-fitter to put the new ones on.

One of my 600 mm stove ignitor is not working.

One of the burners in the gas stove won’t stay lit. It ignites as long as you hold the switch(knob) but it does not stay ignited

Need Gas & electrical check certificate for a 3 bedroom house in Mulgrave

Need Gas and Electrical , and smoke alarm Compliance Checks this week in Pakenham, VIC 3810

I need a certified plumber to disconnect and cap the gas line below the cook top due to kitchen renovation due that the customer will have an electrical cooktop instead. Just disconnect, cap the copper line at the wall. Must provide certificate Probably less than half hr job. Give me an offer and happy to sort out through here or onsite.

Plumber needed to disconnect gas cooktop, seal gas supply.

Old gas connection in living room we believe it was for a fireplace, need a plumber to remove it

We could smell gas and hear some noise so have turned off the meter. Not able to identify whether the meter is causing the leak but is sounded like it.

A sealed gas pipe is sticking out the wall after the wall heater was removed. We need to have a licensed plumber to have it shortened so we can patch the wall.

Hi everyone, I am looking for a licensed plumber or gas fitter to permanently disconnect and cap the gas line to my broken cooktop so I can safely have an electric induction unit installed later. My current setup is a standard 60cm gas cooktop sitting directly above a Westinghouse electric wall oven. The gas is currently turned off at the main valve and the benchtop is laminate. I need you to safely disconnect the broken gas cooktop and permanently cap the gas pipe behind the oven. You will also need to test the line to ensure there are absolutely no leaks and issue a VBA Gas Compliance Certificate, which is mandatory for me to proceed with the electrical stage. Please leave the decommissioned cooktop sitting in the benchtop cutout once disconnected. My electrician will remove and dispose of it later to ensure dust and debris do not fall into the exposed oven casing in the meantime. You do not need to do any physical removal or electrical work. Regarding availability, I work from home most days, so my schedule is highly flexible for you to drop by during the week. Cheers, Sean

I need a compliance check for gas + fixes needed if required. Quote is for compliance check and fixes will be separately managed as needed