Find experienced local fencing contractors in NSW

I have an existing garden fence panel that needs to be moved circa 400 mm back to its original location. Accidentally moved during a renovation and bow blocks the electrical meter. Holes from original location already there, fence just needs to be taken down then moved back Can be done any day before 29/06/26. Probably 1 hours work. Back gate will be unlocked, no one will be home

Hi! I need someone to install a fence/barrier to block off a section of my backyard in Lane Cove. The area is roughly as marked in the photo – it’s a patch of garden/lawn that I need to keep my large dogs out of while a neighbour’s leak issue is being resolved. What I need: • Purchase and install a grid fence (the type available at Bunnings) to create a barrier around the marked area • It just needs to be sturdy enough to keep large dogs out. • Fence posts/stakes to be secured into the ground Location: Lane Cove, NSW Please include in your quote: • Your labour fee Ideally, for this task, it would be best if you could come to my property first and assess exactly what needs to be done. After that, you could go to the nearest Bunnings, which is only about eight minutes away, purchase the required materials (I will cover the cost of the materials), and then return to complete the work.

Need to fix the fallen garden gate.

I need approx 15m of fencing installed, 1.8m high and it will require some posts to attach the fencing I want on to. I will get all fencing gone before job starts. I need you to supply and install the fencing I have indicated which is the Ekodeck 219 by26mm by 3.6m. This is sold in Bunnings. My budget is firm and i can't exceed. If you cant do it between by budget of $3300 to $3700, kindly do not reply.

We have 3 panels of fencing to be repaired we have most of materials needed, some removal of rubbish will be required. Posts need to be installed and removal of the old fence also.

Supply and install a new garden gate about 1.5-2m width

need to remove the old fence, and place a new fence. about 20 meters.

Frontyard fencing and garden gates replacement. Please see attached.

A panel of fence has fallen down at the back of the property. It is very over grown with bush - I need to have the fence repaired so the property is fully enclosed.

Looking for an experienced handyman/landscaper to inspect and repair a leaning timber retaining fence in our garden. The fence is starting to tilt outward, and some of the timber posts/sleepers appear to have shifted or deteriorated (see photo). We need it properly repaired so it’s safe and structurally sound. What’s needed: • Inspect current condition • Advise on repair vs partial rebuild • Repair/replace any damaged posts or sleepers • Realign and reinforce the fence Open to quotes after inspection. 📅 Available for inspection: Tomorrow (13 April), ideally after 10am Please comment with your experience and availability, thank you !

Supply n install Fence, 2x gate, pedestrian gate, fence, auto gate, supply install 1.3m tall.

I need a new fence constructed from wood and installed, dimensions 70cm x 2m, install latch

Repair fallen metal garden gate by refixing it securely to the wall. Install two keyed locks on both garden gates (locks supplied – Deluxe S3 Gate Latch). Ensure proper alignment, smooth operation, and durability. Drilling into the metal frame may be required for secure fitting.

I have an existing fence and I’d like to add half a metre of height in a tasteful way ontop of existing structure.

Hi, I’m looking for someone to repair a metal frame garden gate. The gate has come loose as the screws/hinges have pulled out due to strong wind. Scope of work: Refix and secure the gate properly Replace screws/hinges if required Reinforce the fixing so it doesn’t come off again Ensure gate opens/closes properly Details: Metal frame gate Likely needs new screws/bolts or hinge adjustment Looking for a strong and long-lasting fix

House in need of colourbond garden fencing

Would like to replace the existing garden bed fence with similar size and colour with durable material

Our garden gates and fencing needs to be repaired.. The width and heights of the fencing to be replaced are: - 1st section Width 285 cm height 100 cm to 110 cm. - 2nd section Width 134 cm height 150 cm to 163 cm.  The width and height of the garden gate are: - Width 91 cm height 202 cm max  Please see attached the images. In regard to the material, we would like to use Modwood. Should you need more info please let me know.

We are looking for someone to supply and install a wooden garden gate with a latch. There used to be an old gate there and the holes have already been dug for the support posts. I've attached photos of where the gate needs to go as well as the one that used to be there for reference. I don't need it painted.

Need someone to fix my garden fence

Two gaps tightly filled in the fence line

Supply & install galvanised steel welded dog mesh (rigid not rolls), preferably black or brown, openings 50mm x 50mm, wire diameter 3-4mm. Attach to existing metal balustrade fence to prevent dog escape. Length approx 12m, height 1.0-1.1m from top of concrete at base to top of horizontal fence top.

Need someone to get some metal mesh from bunnings and just come install it on my current gate fence so that my dogs stop escaping

Roughly 20 meters of cyclone fencing that needs to be installed with a gate. Will need top rail and bottom rail. Black coloured fencing.

Rectification of pool barrier defects identified in the Pittwater Pool Certification – Notice of Swimming Pool Non‑Compliance (Inspection Date: 8 January 2026, Property: 41 Therry Street, Avalon Beach). Works required: 1) Clear vegetation/leaf litter to restore 1800 mm fence height. 2) Remove vegetation and wires from NCZ5 and close fence gap to <100 mm. 3) Install 60° capping to oversize posts and horizontal rails on timber screens. 4) Modify retaining timber (remove or 60° cut) where it reduces barrier height. 5) Supply and install a compliant CPR sign

I need to install a metal gate on the side entrance of the house for the pet, about 1.5 meter wide and 1 metre high.

Need a basic fence installed to keep a dog inside the garden. The edge for fence has a bush going along but he is finding ways through. Open to suggestions on best method and type of fence for aesthetic as well as effectiveness. Thanks

Gardeners have whipper snipped a wire it just needs to be wired back together

Install in ground pet fence system at front of house

Provide an install dog fencing

Install a dog gate before going upstairs

Build a temporary fence around a pool to keep out dogs and safe while landscaping happening. Use cheap materials or second hand fencing. 28m diameter around the pool. Budget negotiable

Need an accredited aluminium window and door company to complete a small factory glazing project to its facade Drawings and photos of current site condition attached. Please note drawings differ slightly to what is required, please refer to site photos

I live in an apartment with a terrace that connects to a shared planter area. I have an indoor cat and need a low-height, secure, renter-friendly barrier installed along the planter edge of my balcony. The barrier will likely be lightweight decorative panels or screens (e.g. faux greenery / lattice style). It needs to be: • Secure against wind • Safe (nothing that could fall) • Removable / no drilling into common property • Installed along soil / planter edge and braced against my balcony wall I’m happy to purchase materials based on your advice, or reimburse materials if you source them. Experience with balconies, gardens, or pet safety preferred.

We have this wooden gate at the back of our house which isn’t closing properly and i’d like someone to come check it out and see if they can fix it. It seems like a carpenter kind of job.

1400m section with back collarbond fences fitted with Oscillot rollers. Do you supply the rollers? Or we can provide the rollers Clifton Yamba mentions that our grounds and maintenance supervisor suggested mounting the Oscillot rollers inside the fence rail rather than along the top, to better align with the Site Agreement. Perhaps check with the supplier if these can be mounted on the inside of the top rail? Can you assist? Please provide a quote.

Under the code, it needs to be the following spec Additional minimum of 350mm in height – the wall is 148cm and needs to be 180cm Need a pool fence extension. Either a colourbond slat extension or a glass wall pool extension. There can’t be anything deemed to be a handhold - to prevent them to prevent them from climbing. Each panel needs to have less than 10mm gap. It needs to be flush with our wall If colour bond we would want ironstone to match other panels The wall is 16.15metres long and has a 16.5cm width.

I need an extention built above an already excisting fence as my dog is able to jump it.

**Can bring to you if local northern beaches** Purchased this dog gate online but it requires a drill and install of 6 hinges. Will take 5 mins for someone who has a drill and knows how to operate.

Installing temporary fencing panels (provided) in a garden bed at a golf course to act as a dog enclosure for the golf course guard dog. Must be installed extremely securely and neatly so that it looks strong and level. Need it done asap. Today or tomorrow.

Need someone to assist in securing my yard. Need 1.8m colourbond gate to left hand side of house. (Photo with the monument colour colourbond fence) space is about 1-1.5m wide. Down side of garage need colourbond fence to block from fence to garage (about 1.8m high and 1m wide) needs to be able to be removed. Between house and garage (about 3m wide. 1.8m high) needs to be able to be removed. To do renovations. The corner fence between the new colourbond fence and older style fence I need piece of corner metal drilled into it temporarily until I replace fence (I have done it to the opposite side)

Dig 8-10 holes, cement in posts. Install rails,sheets and a gate, using secondhand materials, to erect an animal enclosure attached to an existing enclosure. Fence needs to be flush with ground.

Install Colourbond Fence Height Extensions I am looking for a handyman or fencing contractor to install height extensions to my existing Colourbond fence. The fence extension panels have not yet been purchased. I am happy to either: - Purchase and supply the extensions myself based on your recommendation; or - Have you supply and install the materials, with the cost included in your quote. The existing fence is standard Colourbond fencing and I am looking to increase the height to ensure it complies with pool safety regulations. As the Colourbond fence forms part of the boundary/perimeter pool barrier, it is required to be a minimum height of 1.8 metres. The current fence height is approximately 1.3 metres. The estimated length of fencing requiring height extensions is approximately 20–22 metres. Please include in your offer: - Your experience with Colourbond fencing or fence height extensions. - Whether your quote is labour only or supply and install. - Any recommendations on suitable products or extension systems. I would like this work completed within the next two weeks. Please provide your availability and an estimated cost.

Need a handyman to replace a broken Colorbond side gate and post as shown. Remove old post/gate, install a new post into the same spot, hang the new swing gate, and fit a standard lock. Please include materials and supply.

Small fence repair to screw the panels back on or replace the fence

After 3 colour bond gates supply and install. Must be able to come and measure and quote job. Approximate measurements 1500x2200 900x 1800 890x 1750

Remove and replace posts in 1800 m/m Colorbond fence.

Instal same colour bokorbond gate from where the down pipe is to the left side

Remove and replace 20m of existing timber boundary fence plus 3.3m side fence including doors. Scope: * Approx. 20m boundary fence * Additional 3.3m side section/gate area * Removal/disposal of existing timber fence * Supply and install new 1.8m high Colorbond fence * Flat block with easy access Photos attached.

I need 18m of colour bond fence installed with sleepers i have all materials

Needing a Colorbond fence installed on all three sides of yard. Ideally to include side gates. Colour Bluegum or Basalt. Must include disposal of old timber fence. Taking exact measurements but block size 778m2.

colorbond fence 25-30m. Supply and install, currently there are metal fence. No trees to be removed.

Boundary Fence: Currently, a Timber Fence, but would like to get two quotes. 1. Colourbond 2. Timber Fence

Need to extend colorbond fence by 30 cm in height. Length of work - each fence 2.36 m wide (total 15 fences and 15 colorbond sheets) Each colorbond sheet needs to be cut in 3 pieces and then fitted into frames. All material already purchased and available. Tools and labour needed. Need a handyman with drill machine and cutter for colorbond sheets and to help with the work. Pls quote for tools and labour. Also quote for whole task not individual fences. Mention time constraints if any.

The bottom of the panel in our gate has corroded through and will need replaced. It looks like the gate frame needs to be taken apart for the new panel to be put in, then welded back in place. Likely a quick job if you have the necessary equipment.

Need to screw in the holder that enables locking for the colourbond gate

Attache two gates on both sides of house as colour bond 1.5 green colors. Thanks as shown in the photo graphs. Supply and instal thanks please. Sorry i am not sure about the cost or prices help me great. VJ

Colour bond sheets and channel rusted and materials are supplied just come and fix the fence all need replacing

Install and supply colour bond fence with Gate to the side of the house. Joining to neighbours fence. Gap is about 1M .

Dog damaged my gate So need someone asap to replace the panels for me please with the same colour. So would need someone that knows where to get it. Pls be aware of the budget