Find a local electronics repairer in QLD

Hi, We’re looking for a qualified mechanic to do a pre-purchase inspection on a 2009 Toyota RAV4 AWD located in Ipswich. The inspection would include a general mechanical check : engine / gearbox / suspension / brakes / a test drive Please bring any diagnostic tools if possible. We are available on Monday 18th, Tuesday 19th. Thank you!

Looking for someone to break down trampoline professionally and pack away into garage

Wanting these 2 stumps & roots removed from garden

I have installed new laundry taps but I don’t have the correct socket to finish the pressure inside.

Builder started the steps. And had to take Another job and left them unfinished. Need them finished this weekend, and finish screwing down some decking boards which was missed. I’m thinking steps only need to go down to where I’ve drawn in red. Hourly rate is fine with me.

I need someone to jumpstart my motorbike which is parked in the cbd.

Replace flyscreen mesh and hold clips

Need some rendering done with gaps in the wall see attached pictures … would prefer render to Match colour of wall .. I can supply product advise me what to get .. located Bundaberg west

I've bought some new taps that I've tried installing myself with no luck. There are two sets, one for each bathroom. Please quote.

We need a rental in Nambour ready for presentation ASAP. *Budget quoted is the hourly rate, photos are being uploaded shortly. Paint touch-ups and caulking throughout the house (3 bed, 2 bath, plus kitchen and laundry), plus outdoor paint touch-ups on Corro Trimdek panels. Not full repaints. Scope of paint and caulking work: - Wall touch-ups throughout - Skirting touch-ups - Ceiling touch-ups where needed - Door and cabinet door touch-ups - Balustrade touch-ups - Louvre window bracket touch-ups - Outdoor Colorbond cladding — clean down and spray -scratched areas - Silicone and caulking work in the bathrooms - Silicone and caulking work in the kitchen - Silicone and caulking work in the laundry Some paint/materials are already on site, but we may need to purchase more — we will cover these and the travel time to pick them up from Nambour Mitre 10 / Duke's Paint Shop. We have other small jobs that need to be completed — ideally, if we can find someone who can do all of these that would be excellent. We are also happy to pay a bonus if these works can be completed by 19 May - we can provide further details on request: Re-hanging four upper kitchen cupboard doors and fitting handles Hooking up a dishwasher and kitchen sink to existing connections Replacing one blistering vanity door in the powder room (new MDF or chipboard, fit hinges) Installing a short run of pool fencing as a balustrade out the back (less than 3.5m lineal metres) Hanging curtain rods x 5 Replacing 2 x plastic toilet seats A few items to drop at the tip — 2 tip runs max Treat Corro roof section (0.5sqm with Ferocite, silicone existing holes) Fix front gate latch Gurni small section of balcony (we have a gurni alread) Fix wobbly timber balustrade at front landing Install 4m of skirting ABN preferred. We pay well and on time for work done properly. If you take pride in a clean finish and a tidy site, this is the job for you.

Smart Door Lock Installation – Philips DDL709-7HWS-C (Front Door) Looking for an experienced professional locksmith to install a Philips DDL709-7HWS-C smart door lock on my front door. Job Details: - Install Philips DDL709-7HWS-C smart lock - Front entry door (approx. 1.2m wide) - Ensure proper alignment, secure fitting, and full functionality - Set up basic configuration (if required) Requirements: - Proven experience installing Philips smart door locks - Must have own tools - Attention to detail is important to ensure a clean and professional finish Location: Park Ridge 4125 Timing: Preferably ASAP (flexible with date/time) Please include: - Brief description of your experience with similar installations - Any photos of previous work (if available) - Your quote Looking for someone reliable who can get this done properly the first time.

I need a quote to completely remove 3 x small trees & remaining stumps

I have two food grade 1000l IBCs that i need the tops chopped off. This will involve measuring and cutting the metal cage and the plastic container. You will need to bring your own tools such as a angle grinder/cutting tools

HI Taskers – I need two vintage lamps re-wired and checked over. They currently have American plugs so need to fix that. Also one has a bulb mount that needs to be re-mounted.

There are currently x8 door stops installed at the property, x4 plastic and x4 rubber. All are currently screwed into the doors rather than the skirting. We believe there isn’t much longevity with them being screwed into the doors, as the doors are quite thin, so could you please provide a quote to relocate the door stops and fix them to the skirting instead?

Have cut down bamboo but now need clumps and root system removed.

Recently renovated, need stone bench tops cut and polished nicely.

Install Barge Caps (Monier Roman supplied) onto new front porch roof

we need a concrete cutter to cut off chunks of thick bamboo stumps that preventing us from building a fence. we cant get a stump grinder mainly because of the access.

3 x stumps ground and removed