Find a local electronics repairer in South Moreton Bay

Quotes for someone to Cut down 2 thin trees, remove waste and the poison stumps

Hello I need someone to put wooden transition strip or rubber carpet transition strip for 4 bedroom, 2 bathroom doors ways guests room area. Very easy job but don’t have the time to do it.

3 hedge stumps from the front yard need to be ground, along with a grevillia stump from the backyard.

Have 3 walls that need a bit of a touch up/tidy for end of lease. Also Wood that’ll need a filler and sand and touch up on stairs

Hi need someone install sub amplifier reverse camera to my Holden commodore ve 2010.

Need 2 stumps dug up and removed.

I need a new Coops & Cages cat patio constructed please. I have the boxes here & instruction manual enclosed in unopened boxes. I have a unique code CCFBJ7BB9

Replace Vanity Taps I need someone to replace the taps on a standard bathroom vanity. I originally intended to replace the washer, but the spindle is too tight for me to unscrew. I have already purchased the new replacement taps, so the job is simply to remove the existing taps and install the new ones. Details: * Standard bathroom vanity * New taps already purchased * Existing taps need to be removed and replaced * Photos attached * Flexible with timing — anytime this week * Ideally looking for someone experienced with basic plumbing/tap replacement Thanks for your quote.

Repair roof flashing approximately 10 meters and coating touch up. I will provide coating material left from previous repair/painting. $350 + material cost

I need an 8 Gauge wire directly hardwired to the 12v + on the Sony Xplod Amplifier Circuit Board

My original task expired - Paul, please contact me to book. I have 1 x approx. 10cm across Yucca Stump and 4 x Other Clumped type stumps in a garden bed I need dug out.

Have some painting to be done, the edges are chipping, just needs touching up. There is one patch that will need bogging,

I'm looking for an experienced appliance repair technician or qualified electrician to diagnose a fault with my Blanco freestanding oven. The appliance has a gas cooktop and electric oven. The gas cooktop works perfectly, but the electric oven trips the mains/safety switch after running for a short time. We can reset the switch and restart the oven, but it trips again after heating up. I'm looking for someone to: Diagnose whether the fault is inside the oven (e.g. heating element, thermostat, wiring, etc.) or with the electrical supply. Advise what needs to be repaired. If it's a straightforward repair and parts aren't required, complete the repair on the spot if possible. Please bring the appropriate testing equipment and let me know your experience repairing Blanco ovens. Location: Murrumba Downs, QLD Budget: $120 (diagnosis only, with any repair or parts to be quoted separately).

Hi need a handyman at bula bites cafe north lakes who can fit benchtops and cabinet

Our taps are leaking and there is water underneath sink, we need to change our taps.

Quote for replacement of kitchen benchtops. Quote for bot stone and laminate please

According to roadworthy guy, there are no bump stops at the front of the motorhome. I have the parts just need someone who knows what they’re doing to fit them.

See pix. Repair of small chips and rust marks. Note: Not all rust marks shown. There may be one or two more. Feel free to pop around to inspect. Thanks

Please provide quote and availability. I've removed the old taps and shower head and cleaned off old silicon around them. I bought new valves, taps and shower head. Want to reseat tap seats and then install new valves, taps and shower head. Also seal up taps and head with silicon. The shower wall is ~5mm sheet and a hollow cavity behind, so not sure if need some sort of backing for the silicon.

The power circuit for the kitchen area keeps tripping at the switchboard. Even when all appliances are unplugged and nothing is being used, the safety switch/circuit breaker continues to trip randomly. Looking for a licensed electrician to inspect and diagnose the issue, identify the cause, and provide a quote for repair. Location: Bunya, QLD Please let me know your availability and estimated call-out fee.