Find a local console repairer near you

Got a collapsed shed that needs to be removed. Galvanised steel.

My Hager 16A RCBO (Power 7) trips immediately and cannot be reset. I've already completed the following checks: • Unplugged all appliances connected to the affected circuit. • Turned the hardwired fireplace fan wall switch OFF. • Switched the RCBO fully OFF and then back ON to reset it.

Rodent exclusion + trap setup in roof cavity We've got mice getting into our roof cavity and want them dealt with properly — not just baited so they keep coming back. The job has three parts: Find the entry points — inspect the exterior, roofline, eaves, vents, weep holes, pipe/cable penetrations and roof tiles for any gaps a mouse could get through (they only need about 8mm) Seal them off — close all gaps using steel wool packed into expanding foam, and metal mesh over any vents/openings that can't be fully blocked. Mice chew through foam alone, so steel/mesh is important. Set the traps — access the roof cavity through the internal manhole (note: this is a low Australian-style roof space accessed via a ceiling hatch, not a full walk-in attic, so it's tight and requires care on the joists) and place snap traps along beams and wall lines where mice travel. We supply: snap traps, peanut butter, a ladder, and a head torch. You supply: sealing materials (steel wool, expanding foam, metal mesh), hand tools, and appropriate PPE (gloves, dust mask — roof insulation and dust).Single-storey home in Hadspen, TAS. Please bring your own materials for sealing (let us know if you'd prefer we purchase specific products in advance). Take before/after photos of the entry points found and sealed so we know what was done. Let us know if you spot signs it may be rats rather than mice, or any other damage (chewed wiring, nesting) while you're up there.

Remove or grind a clump of palm tree stumps in a raised garden bed, which have roots growing into a nearby down pipe. Looking for advice, a solution and a quote to remove the stump and roots from downpipe.

* The toilet is not flushing properly because water is not coming from the cistern (tank) into the toilet bowl. * The bathroom floor drain is draining very slowly. * The hot water mixer knob in the shower is loose and keeps falling down. * The kitchen tap is also loose and needs to be fixed.

• Replace the kitchen tap with a like-for-like tap set. • Replace the laundry taps with like-for-like taps. • Install and plumb in a new laundry tub. All labour cost only.

Shower head was leaking so we diy fixed the taps which fixed the shower head problem, but now the taps are leaking when in use

Repair 2x small chips on engineered stone benchtop edge (~10mm). Looking for colour-matched fill and polish to blend with surface.

I have 3 x Google Flood light Cams (wired) and 2 x Philips Hue outdoor lights (wired) that are to be installed in my single storey home externally (outside garage, alfresco etc. - sample placements in pics to get an idea. New switches x 5 to be added (supply +install basis) by tasker and also any wiring/supplies required. I can only provide the 5 x lights mentioned above. These will be fresh installs with a certificate of electrical safety. Happy to answer any queries.

Looking for a licensed plumber to replace the existing separate hot and cold taps with modern mixer tap fittings as part of a bathroom renovation. Scope of Works: * Remove existing hot and cold shower taps. * Install new shower mixer. * Remove existing hot and cold bath taps. * Install new bath mixer. * Pressure test and check for leaks. * Ensure all work complies with Australian plumbing standards. Additional Information: * Bathroom has already been stripped back for renovation, so access is straightforward. * Mixer tap bodies and fittings can be supplied by me (please advise if any additional fittings are required). * Please include labour and any standard consumables in your quote. * Located in Holland Park West, QLD. * Flexible with timing over the next 1–2 weeks. Please let me know: * Whether you are a licensed plumber. * Your availability. * If you require any photos before quoting.

My car is parked on the Kingsway at Caringbah.It is parked on the hill on the side travelling towards Cronulla.About 50 metres down from Caringbah station.So it's in a difficult position for a jump start.Yet this is what I need as I have a flat battery.Can anyone assist me to get my car started?

Looking for someone experienced to complete the removal of several plants and dispose of all green waste. Scope of work: * Remove and dispose of the pile of green waste already cut down (see photos). * Dig out and remove the remaining Bird of Paradise stump/root ball (already cut back). * Remove one clumping palm (including roots where practical). * Remove all green waste from the property and leave the area clean and tidy. * Sweep/blow down the area once completed. Notes: * Photos show the exact amount of work required. * Easy access through the side gate. * You will need to bring your own tools and trailer/ute for disposal. * Please include all disposal/tip fees in your quote. * Located in Wishart, QLD. When quoting, please let me know: * Your total fixed price (including waste disposal). * When you can complete the job. * Whether stump/root removal is included in your quote. Please refer to the attached photos for the current condition of the plants and waste.

I need these 5 units - units 6 screws on the top and 6 screws on bottom per unit dismantle and taken upstairs and assembled again. Urgently today or latest tomorrow morning

We bought Shaw and mason basin set and need someone to install it

We need installation of replacements for the following (all purchased already): - 1x Sink Taps + Spout - 1x Bath Taps + Spout - 1x Shower Taps + Showerhead Licensed plumbers only.

End of lease paint repairs. A couple of small holes, marks where screws have been / stick on hooks. I’d say 2-3 hours work. You will need to do paint matching / etc. happy to reimburse for paint. Send me an offer.

My air conditioner keeps tripping the main switch.