Find trusted local electricians in SA

I am seeking a Licensed Electrician to install a dedicated 32A 5-pin (3P+N+E) industrial switched socket near my main switchboard. Specific Requirements: * Socket: Supply and install a Clipsal 56 Series 32A 5-Pin Switched Socket. * Wiring: To be wired for Single-Phase operation (Active on L1, Neutral, and Earth). * Cabling: Must use 6mm² cable for a dedicated circuit (approx. 50 cm from the board). * Protection: Supply and install a dedicated 32A Clipsal (or matching) RCBO safety switch. The switchboard has no spare poles. Please supply and install a enclosure directly onto the internal backboard of the switchboard box to house the new RCBO * Compliance: An Electrical Compliance Certificate (CES/CoC) must be provided upon completion. Site Details: * Switchboard is located in the garage. * Clear access for mounting.

X2 PowerPoints need fixing

Install 5 light fittings Replace 2 globes in ceiling fan that keep blowing

Fix 2x new air conditioning in rooms

I need a licensed electrician to install 1 new induction cooktop and 1 new underbench electric oven at my home in Athelstone SA 5076. This is a hard-wired installation. I would like the electrician to first inspect my existing wiring and setup, as I am not sure whether the current cable, breaker, circuit or isolator meet current requirements. As shown in the photo, the existing wiring appears to come out from an internal brick wall partition as one brown cable, then goes into a junction box, where it is split into two white cables. One white cable is connected to the old cooktop and the other is connected to the old oven. Please let me know whether this existing setup can still be used, or whether any upgrade, new circuit, isolator or other electrical work is required before installation. Please provide a quote for labour and any extra materials separately. Licensed electrician only. Invoice and certificate of compliance required.

Lights not turning on after rain

1. Replace one down light in pantry 2. Repair/ replace bathroom fan 3. Repair/ replace a fan in bedroom. 4. Check a few powerpoints and repair if needed. 5. Replace outdoor lights (5)

Require the roller shutter motor to be replaced in the kitchen of my grandparents house. We have purchased the part and have a qualified electrician to wire it, just need someone to do the labor. Have attached image of what the part is.

We have 9 wall sockets not working in Kitchen and surrounding, which all connects to one breaker on the switchboard. Changed the circuit breaker, and 4 wall sockets that were looking like could be problematic but no improvement. Initial warning before those wall sockets fully stopped working, when we start 2-3 items it was dimming the lights that were connected to that socket. It never tripped any circuit breaker or RCD on the switchboard, directly stopped working those sockets, lastly started the dishwasher, which socket also I changed,

There's 4 downlights I popped one out and realised they're hardwired so I said I'd better get somebody qualified the cutouts are 90 mm and there's roof access in the same room

Removal of 2 x Lights (external) - priority/asap Additional task: Installation of a ceiling fan (and downlights if possible)

I am looking for quotes from a qualified and insured electrician to install one double PowerPoint in a new laundry recess. I also need existing light repositioned and replaced with a downlight and one additional downlight install in hallway outside laundry recess.

Need an electrician to help with kitchen Reno’s. Scope: - put 3-4 new power outlets in, including running a wire on the ground to the new island (tile has already been removed so no digging/jackhammering should be required) - terminate and close off (plaster?) old power points/wires - put in new power for oven (there is a socket right next to the oven) I estimate it to be about 2 hours of work.

Remove existing light fitting and replace with a different one. Pictures of the existing one and the replacement one included. Not sure how the new fitting will be held up but hopefully you can also problem solve that.

I need a power point relocated to another area of the wall due to a wardrobe installation that will cover the current one. I also have a few other power points that need to be inspected as they buzz and short circuit during use sometimes.

We require a licensed electrician (or qualified apprentice working under supervision) to complete the second fix only for a relocated kitchen. The first fix has already been completed. All cables have been run and are ready to connect (run cables ready to connect). Scope of work: Connect electric oven Connect electric cooktop (hotplate) Install and connect 6 power points Make necessary junction connections between the old kitchen electrical lines and the new kitchen location Access to ceiling cavity is required All materials will be supplied by us, except junction boxes if required. This is second fix only. No cable pulling or first fix work required. The job is expected to take approximately 1–2 hours. Must be licensed and able to provide a Certificate of Electrical Compliance / completion upon finishing.

Task: Replacement of two faulty light switches. Details: • Laundry switch: Currently stuck in the “on” position and the light won’t turn off. Needs replacement. • Hallway switch: Also requires replacement (not functioning properly). • Both switches are standard light switches. What I need: • A qualified electrician to supply and install two new switches. • Ensure both switches are safe, compliant, and working correctly after installation. Location: Laundry and hallway inside the home. Preferred timing: Flexible — anytime that suits within the next few days.

I got lan cable installed previously from one room to another but the wall sockets has telephone ports. I need to update the wall sockets to cat6 sockets. The cabling is anyway cat6.

Needing electrician for our extensive house renovation First to come out and cap off before demolition (early Feb) and change a couple power outlets then come back to install new lighting (chandelier, 3x pairs wall lights for bathrooms and 1x pair exterior wall lights) you can quote any other work needed on the job when you come to site to inspect Price in ad doesn’t reflect your final price

Need a power point installed external on a brick veneer wall. There is a power point internally directly inside the wall. It is under cover outside so no special durability is required.