Find trusted local electricians in Kellyville

1. Replace bunker light at the main door; 2. Install sensor flood light outside garage (including wiring, switch & power connection; 3. Install flood light in the backyard (including wiring, switch & power connection)

Two indoor power points, one outdoor PowerPoint, two outdoor wall light.

Need 24-25 down lights in the house, can supply the downlights , pls quote , need for level 1 , 30$ per light is my budget, pls quote your price which includes installing the light and wiring plugs etc

Need to replace 2 electrical switches

My outdoor sensor light which is controlled by a switch is turning off and on at night unexpectedly even when switch is off. When it is switched off, it still turns on/off and there is no way of turning it off at night. I believe it might be a faulty switch or sensor.

I was replacing a ceiling light, the RCD tripped, and now the RCD will not stay in the ON position. The house also has solar and a Tesla Powerwall backup system. Switchboard is located outside of house - we have another issue. The house is locked, and our only access is through the garage door using the remote control. Unfortunately, the garage door isn’t working because there is currently no power. Do you have any suggestions on how we can get access so you can carry out the electrical work?

Looking for a qualified, licensed electrician or electrical contractor to carry out a series of lighting installations. All of the light fixtures are already purchased and will be supplied on-site.Please review the complete scope of work detailed below. Scope of Work and quantity Install of standard 25x 90mm downlights and plugbases (Fixtures supplied by client) Installation of 1x pendant light in the walkway (Fixture supplied by client) Installation of 3x tracking lights in the lounge room (Fixtures supplied by client) Installation of 3x pendant lights in the kitchen, note there’s existing timber for the structural cross beam install in the ceiling (Fixtures supplied by client) Requirements for Applicants Must hold a valid, current Electrical Contractor or Electrician License (please provide license details with your offer). Must provide an Electrical Safety Certificate upon completion of work. Must bring all standard trade tools, ladders, and rough-in materials needed to complete the installation. Must clean up and remove any wire clippings or installation debris from work zones.

Need to put in two downlights in the walk in wardrobe. As well change the switch

2 storey housr. Living Room ground floor : Additional electrical sockets on separating wall which don't have sockets at the moment. Living Room : fix ceiling light Got all the fans and light pendant. Hall way : fix hanging lights bulb changing (high ceiling) - Optional Bed room: Additional electric socket 5 Bedrooms: fix fans Repair one loose electrical socket in kitchen Must be certified electrician. Please provide your company name in the quote.

I need to move 3 downlight openings on the ceiling of the first floor in a double-storey house. The work includes: 1. mend current holes 2. paint the mended holes 3. make new holes

replace approximately 25 LED downlight bulbs I have the replacement bulbs - just need someone to change them

Move GPO by 5-15 cm, add a new GPO on the wall above

Supply and install two led downlights

We have four outdoor sconces that need replacing. I’ve included photos. Replacement light is a Philips hue sconce photo also included. Inside switch currently has three buttons. Need this replaced with a two button panel and the circuit for the outdoor lights to remain on so that the smart switching will work. I have the replacement panel and two switches.

Bedroom TV Wall * Install a recessed TV wall box (supplied by me or included in quote) suitable for: * Double power outlet * TV antenna point * Data/CAT6 point * Position box at TV mounting height. * Relocate/extend existing cables if required. * Leave ready for future wall-mounted TV installation with hidden cables.

Looking for an experienced and licensed electrician to complete the following works: Existing Wall in hall * Remove/dummy off electric board behind wall in compliance with Australian standards.. Are you a licensed electrician for the electrical work? Requirements * Licensed electrician required for all electrical work. * Please include labour, materials and disposal in quote. * Photos attached.

Down lights in restroom is not working and need to change them

I am looking for a licensed electrician to install a Tesla Wall Connector (Gen 3) at my home. Requirements: * Valid Australian electrical licence. * Experience installing EV chargers, preferably Tesla Wall Connectors. * Install, test, and commission the charger according to Australian standards. * Provide any required compliance certificate/documentation. Details: * Tesla Wall Connector already purchased and available on site. * Three-phase power available. * The charger needs to be installed inside the garage. * The cable needs to pass through the wall from outside to inside, as shown in the attached photos. * Please provide a quote including labour costs and all required materials, such as cabling, conduit, ,and any other installation materials. Location: North Kellyville, NSW 2155 Please provide details of your licence, relevant experience, and availability.

Kellyville. Looking for a licensed electrician to complete a few small electrical jobs at a residential property. Tasks include: • Replace the small base and cord of a room light. The existing cord needs to be removed and replaced with a new one. Access is via the roof cavity. Roof access is easy and only about 2–3 metres from the entry point. • Replace 2 outdoor GPO wall outlets. • Replace 1 circuit breaker in the switchboard (smart circuit breaker to control HWU) All materials are already supplied (cord, GPOs and circuit breaker). Straightforward job for a qualified electrician. Please bring your own tools.

Looking for an electrician or experienced handyman to replace a few cracked wall plates in my home. Work required: • Replace 1 x light switch wall plate • Replace 2 x double power point wall plates • Ensure all switches/outlets are secured properly and sit flush against the wall • Check everything is working correctly after installation The existing plates are cracked, so they just need swapping for new ones. Wiring should remain the same. Photos attached showing the current setup. I'm happy for you to supply the replacement plates (standard white) or I can reimburse for materials. Flexible with timing but would like it done sometime this week or next. Prefer someone with electrical experience (licensed electrician ideal) since power points are involved. Should be a quick job (likely 30–60 minutes).