Find trusted local electricians in Hawthorn East

I need a licensed electrician to fix my Miele cook top in the apartment, the error code is E31, and the switch is tripped when trying to use, after turn on the switch, the cook top didn’t work, so please let me know your charge/fee and availability if you can do it.

I want to get 2 power point on the 3m long wall!

My Rheem Pronto 12 gas hot water system is not working properly. The main issue is that the hot water only runs for 1-2 minutes before the pressure drops and it turns completely cold. It likely needs a service and the filter cleaned. I am looking for a licensed technician to diagnose and fix the problem. Please provide a fixed-price quote for the service and repair. Thank you🙏

Mitsubishi Electric split system not blowing cold air

My Rheem Pronto 12 gas hot water system is not working properly. The main issue is that the hot water only runs for 1-2 minutes before the pressure drops and it turns completely cold. It likely needs a service and the filter cleaned. I am looking for a licensed technician to diagnose and fix the problem. Please provide a fixed-price quote for the service and repair.

My Rheem Pronto 12 gas hot water system is not working properly. The main issue is that the hot water only runs for 1-2 minutes before the pressure drops and it turns completely cold. It likely needs a service and the filter cleaned. I am looking for a licensed technician to diagnose and fix the problem. Please provide a fixed-price quote for the service and repair.

Solar disconnectionissues

Hi, I need a plumber to help with my outdoor Rheem Stellar gas water heater. • Currently, no hot water in the house. • I checked the unit and found that the pilot light might has gone out. • I tried to relight it, but the piezo igniter seems to be faulty (no “click” sound, no spark). What I need: • A plumber to come and check the system. • If it’s just the pilot light issue, please help relight it safely. • If the igniter is broken, I’d like it replaced with a new one so it works properly.

Need to remove 5 pendant lights in Victorian home and replace with new pendant lights (which we have ready). Need to saw 20ml of length of rods on each light.

My movers broke the existing light fitting Need a new one installed & a new power point on the other side of the wall

I would like a chimney fan installed in place of the existing cowl and then have the fan wired to mains and the control point installed into a wall or onto brick inside - photos will help you understand what is required The fan weighs approximately 20kgs. Roof access incredibly easy. I think wiring just requires conduit down the side of the house and wiring inside. Once I know what prices are and whether someone can do the work required I’ll order the fan.

My 3 phase power swit h keeps turning off

Removal of outdoor electrical unit connected to side fence. This fence will be removed after.

Job Description: Looking for a qualified handyman or electrician to reconnect a loose wire to a power point. It’s a small, straightforward job – perfect if you’re in the area and want to make a quick $100.

Electrical wires connected to the garage was cut off, looking for an electrician to splice it back to a power source to start up the garage again.

I need to install a 3 phase power outlet in my garage to charge the electric car. The main power box is located in the garage too.

Just to add additional lighting point and power point l. Propertys plaster board is under renovation now. Looking to add the point before plastering n rendering

Looking for a quote to move NBN box (FTTP) from one room to another, about 6 metres.

I have 2 downbulb to replace easy however I’m recovering from injury but sensor light no longer works hence need quote I am located in Hawthorn East I’m not sure cost so Will choose

Require 1 downlight to be replaced on the kitchen ceiling. The light will be sourced.