Find trusted local electricians in Inner South West Sydney

Supply and install 98x 475w Longi solar panels and 6x 10kw sigenergy batteries, Sigenergy 30kw inverter, gateway backup

Electrical board upgrade to 3 phase, building granny flat at the moment and need the front house board upgraded and new sub board for granny flat. Please see image of what’s required.

For a licensed professional electrician to install four downlights in the new ceiling of our kitchen and also install an electric oven and install a double PowerPoint from the current rough in work down by another electrician

Looking for a licensed electrician to install two additional power points in a bedroom. One will be near my work-from-home desk for a computer/monitor setup, and the second will be next to the bedside table. The existing power point is on the opposite side of the room. Looking for someone to assess the best option to install the new points and run any required cabling neatly. Please include labour and materials in your offer.

Need an electrician to replace existing sensor light with wired arlo spot light

Test Switch: A designated test switch for the emergency and exit lighting system, allowing the system's battery backup to be safely and manually tested without cutting the main power supply. Enclosure: A suitable protective housing or weatherproof/surface-mounted box to safely house the test switch and any associated wiring in compliance with safety standards. Contactor: An electrically controlled switch (relay) used for switching the emergency lighting circuits or tying them into the building's emergency testing grid as required by the compliance report. instructions for - electrician that these items must be installed and tested so that you can provide a compliance sign-off or certificate to Centre

Wanting certified electrician 1. change outdoor security camera from back of house to front of house. 2. add a switch with front camera 3. add outdoor security camera at back of house using existing electrical output for old security camera at back of house. 2 Ladders provided. Location = Allawah Prefer Weekends

Fixing of wire (illegal wire connected to a wall plug addon)as seen on photos from laundry to winter garden, moving of oyster lights x2 about approx 500mm, installation of a light with switch in one room. Then another room with a light, switch and power point

Need to install bird mesh for 23 Panels in a double story house

Existing cooktop is a GASLAND CH60BF, 60cm ceramic electric cooktop. Current cut-out is approximately 560 x 490mm. I’m looking to replace it with another 60cm ceramic cooktop of the same cut-out size so no stone cutting should be required. I can supply the replacement cooktop. Looking for removal of the old unit and installation/connection of the new one.

The RCD labelled “Protected Power” (C20, 30mA) trips the instant I switch it on, so all power points are dead. Lighting circuit is fine. Cause is known: insecticide spray went into one power point and the tripping started immediately after. The RCD has been off since and I haven’t touched the outlet. What I need: the affected outlet inspected and replaced, and the circuit tested.

I currently have a Martec Contour 2 connected to a 3 gang switch and the fan exhaust is not working so needs to be replaced. The main bathroom lights and lights on Martec unit are on the same switch. I plan on buying Martec Profile 2 and need an electrician to help replace and connect to 3 gang switch. This may require existing cutout to be extended to fit new system. Any recommendations on any other bathroom heater and fan exhausts are welcomed.

I have an external power point that I need installed by a licenced electrician. I will supply the materials (external weatherproof power point)

I need to replace 2 power points and 2 light switches. 1 set is in the bathroom on a tile and the other is in bedroom. I have the replacement parts. Just need to replace them and fit them on the wall/tiles

I am looking for a fully licensed NSW electrician to supply and install one new extra power point in a bathroom at a single story house in Padstow and able to provide CCEW. Just take extra care of the wall tiles.

I'm looking for a licensed and insured electrician/gas fitter to complete the following work at my property in Arncliffe, NSW, as soon as possible. Scope of work: Rangehood Replacement Remove existing rangehood. Supply not required (I already have the new unit). Install a new Solt 60cm Slide-Out Rangehood (Stainless Steel). Gas Cooktop Replacement Remove existing gas cooktop. Install and connect a new Chef 60cm Gas Cooktop (Stainless Steel). Ensure the appliance is tested and operating safely after installation. Requirements: Must hold the appropriate licence(s) to carry out the work. Please bring any standard installation materials if required Please provide a competitive quote before commencing the job. An invoice is required upon completion. The job is located in Arncliffe Please contact me with your availability, licence details, and quote. Thank you!

Need a licensed electrician to replace 3 light switches, 3 double power points and 1 bathroom batten light fitting. I have already purchased all the replacement fittings. Please install them and test that everything is working properly. Photos attached

Need some cables running in kitchen for new power sockets On the image, the Red is existing power The left hand corner is where the mains power for the cooker is which will need running behind to where the new cooker placement is going. I’ll need power new slot which is the green section and there is another PowerPoint below at the bottom of the kitchen the back which will be used for the cooktop but currently doesn’t seem to be given off any power.

I have purchased a ogemray smart relay 25a (powered by shelly) so I can control my hot water from the Shelly app. This can be installed in the fuse box of inline, near the hot water. It is a simply job that I could do myself, but I prefer an electrician to do it. I would like someone today or tomorrow if possible.

Hello! I'm looking for a licensed electrician to replace two existing ceiling light fittings (one in each of two rooms) with new pendant lights that I have already purchased. Job details: Remove 2 existing ceiling light fittings. Install 2 new pendant lights (supplied by me). Ensure both lights are securely fitted, working correctly, and safely installed. Please bring any standard tools and small installation hardware that may be required. Preferably today or tomorrow. Thank you! 🙏 Magda