Find trusted local electricians in Perth

Someone who can help me saving this thing going to landfill. It was working only a few weeks ago, but since I moved it into my gym, not registering distance or strokes on the LCD display. It turns on and I am able to use it. Just wire or sensors not registering the data. I have been told it could be a loose cable connections or something else related to the sensor non working problerly. It would suit a "radio club" expert, in electrical and wired components. If you need any specific photos happy to take some and send them. The three connection 2pin cables are from the sensors and one for power I believe. When I connect the power all works but as above-mentioned no distance or strokes recorded. I am hoping is a quick and easy fix for the right person!

Lights on balcony flickering on and off - I have been told it’s most likely the switches are faulty but I’m looking for a diagnosis and fix. Also the one door living area /kitchen spot lights some don’t work

Vacant office in West Perth. Accessible anytime, keys on site. Works needing completed before 9am Saturday 1st Nov. 1. Disconnect and remove hardwired pendant light fitting, safely terminate cables in ceiling space. Dispose of light fitting 2. Supply and install 5x replacement Finetta fine fissured ceiling panels, one needing cut I half, to replace panels with holes in them, and one that is sagging by the balcony window. Dispose of old panels Ceiling height approx 2.7m

I need a single GPO installed in my bathroom next to the cistern to power a bidet toilet seat. Also the power cable attached to the seat needs to be shortened to suit power point location. The install is on a single brick wall. It backs on to a wardrobe which can be used to bring cabling down from the ceiling space.

Looking for a qualified electrician to complete some lighting changes at my single story property in Inglewood. Scope: -Disconnect and remove 4x existing ceiling lights -Install 9x downlights (cut holes, fit lights, connect wiring) -Supply and install new light switches (dimmable required) Downlights will be supplied (as per pictures). Although all cable, switches, fixings, consumables etc will need to be supplied.

Hello! I’m looking for a skilled electrician to help install lights and set up circuit boards in my new shop. If you have experience with commercial electrical work and can ensure everything is up to code, I would love to hear from you! If you’re available, please let me know your rate and any relevant experience. Thanks so much, and I look forward to working with you!

Switch from tank to tankless water heater.

Hi, I am in urgent need for electrician who would be able to unplug and disconect 4 power outlets. It should be a quick 1-2h job. Need get it done by Sunday.

I need some lighting removed and new installed. 3 rooms. 6 cables to be made safe. 1 light fitting to be replaced. High ceilings

Needing a GPO installed on external wall. House is single storey, double brick with roof access. Refer to photos - somewhere in the marked up area ideally.

Certified electricians only please. Need electrician to fix power plug of my pool chlorinator. Dog has chewed it.

Hi I need two additional electrical outlets installed in a loft space - already powered. One is under an air conditioner as shown so access to power should be ok The other is near a desk with an existing outlet on the wall to the left so also hoping access to power is ok installing festoon lights on a balcony as shown … need a ladder - keen for it to zig zag overhead—- from balcony railing overhead to above the glass sliding door … material to drill hooks into is metal . Electrical outlet is already in place for this so can just be plugged in

I need an experienced auto-electrician or caravan/solar expert to help me diagnose/check/remedy my portable solar panel setup. I want to increase solar power input and battery storage to my caravan when I'm travelling 'off grid', so I have setup a portable solar panel system; this is fully separate to the caravan's existing 400w roof-mounted solar panels. The solar power setup that comes with the caravan has 400w solar roof panels that feed directly to the van's lithium batteries via a Redarc Manager 30 BMS. To augment that supply, I have 3 x separate portable solar panels (with a total output of 590w), that I setup when stationary/camping. These panels feed to the caravan batteries via their own regulator/controller; the feed is direct to the batteries, bypassing the van's Redarc management system, so the two systems are not connected. The problem I have is that the portable panels work for a while (delivering increased amperage to the batteries over and above that generated by the van's roof panels) but after a while they seem to cut out and I get zero amps delivery, even in full sun. Could be the MPPT controller/regulator is acting up or some of my connections, not sure! So - I need help with isolating the problem and remedy! If you are good at diagnosis and know one end of a multi-meter from the other, an hour or two on-site should be sufficient for the task. I will have the panels setup ready for inspection.

I have some smoke alarms which need certification certificates for home sale.

Ceiling plasterwork needs to be made good in one room where light fittings have been changed. In a second room the ceiling plaster needs repairing before the light fitting can be replaced.

I have a telephone port in the centre of the apartment that I need troubleshooting to enable NBN connection. I am currently using the telephone port at the back of the apartment. I believe it needs to be jumpered from krone box just outside our apartment door to extend to this port in the kitchen. That way we have 2 working telephone ports.

10 year old new build house with too many circuits all on one breaker. Using the toaster and kettle at the same time causes breaker to go off

I need two light switches swapped with new ones . Roof leaked into them last night. Power is off, so no live work required. I also have the replacement switches. Just swap and go.

I am looking to have either an exterior light installed or failing that, a power point so i can plug my own light in. There is power going to the air-conditioning unit outside that I am hoping can be tapped into. Otherwise there is a powerpoint inside the apartment just inside the sliding door. shown in the 3rd photo Obviously needs to be done by a qualified electrician. I can send a video of exactly what I am trying to acheive

Relocate an NBN wall connection to another location in the house.