Find trusted local electricians in North Brisbane

I am looking for a licensed electrician to supply and install two external weatherproof double GPOs on the external brick walls of double-brick house. - One at the front of the house. - One at the rear of the house. - Include all materials, wiring and fittings required. - Test both GPOs once installed. The electrician can assess the existing electrical setup and determine the most suitable wiring route and connection to a suitable power circuit. Please provide a quote inclusive of labour and material and compliance certificate.

Replace bulb, or replace unit with REEF, Check and repair bathroom down lights Sometimes works/mostly doesn’t Affix kitchen power point Advise on use of Fronius Solar system

Hi all, I’m planning to install a precast pool in my front yard, and the existing electrical conduit/cable is slightly in the way of the pool excavation. I need it relocated approximately 50 cm closer to the house. The current conduit is about 1.3 m from the house. I’m looking for a licensed electrician who can: - Safely isolate the power during the pool excavation. - Relocate the electrical conduit/cable closer to the house by approximately 50 cm. - Ensure all work is completed safely and in compliance with relevant electrical regulations. There is a concrete footpath over the area that can be removed to allow access for the relocation. Please let me know if you can assist and provide a quote. Thanks!

Whole house went off check main switch all good all neighbours has power

Light switch is stuck in position and unable to be switched off. Looking for liscened local electrician to fix. Please let me know your availability for this task and include in your quote: airtasker fee, and total costs for inspection and repair.

connect de walt 3 phase EV charger (Bunnings) to 3 phase socket already installed

I have no ceiling lighting in 2x bedrooms - due to removing lights from fans. I would like small LED down lights installed in both bedrooms - including dimmer switch (I'll obv buy all the parts). Licences electricians only, please.

Need AC repair technician. Daikin AC keeps on flashing.

Looking to swap 3 ceiling fans to black ones - Not sure how much it costs in labour.

These are the tasks 1. A ceiling fan is moving extreme slowly, even on the fastest speed. The fan controller was changed recently to rule out the capacitor issue in the controller. This fan needs to be checked to make sure it is spent and I have bought a new fan that needs to be installed. 2. Similar fan in another room is working fine, but it’s directly below my bedroom and it makes a lot of noise. The plan is to move that fan in place of the one that is not working and install a new one, which is hopefully quieter in its place. 3. The floodlight in my backyard is not strong enough and needs to be changed with a strong floodlight, which I have bought. 4. The outdoor siren unit in my Motion sensor system which is wired is making constant clicking noises. I just need to understand if it is just a battery issue or something else is wrong. Ideally, I would love to pay the hourly rate for this job, but happy to discuss the options

I’m looking for a licensed electrician for a small job at my rental property in Clontarf next Wednesday, 7 October. There are two jobs to complete: - Remove the existing electric cooktop and install a new replacement cooktop - Replace a faulty/intermittent light switch I’ll purchase and supply the new cooktop and switch beforehand, so I’m really just looking for someone to handle the electrical installation and connection. I’ll be at the property at the same time doing a few minor maintenance jobs, so access is easy and there’s no need to coordinate separately with the tenant once the time is locked in. The cooktop is being replaced rather than repaired, so I’m not looking for fault-finding on the appliance itself — just removal of the old unit and installation of the new one. Ideally looking for someone who: - Is a properly licensed electrician - Can complete both jobs in the same visit - Is available Wednesday 7 October - Can provide the appropriate electrical safety/compliance documentation Clontarf QLD 4019. Please include your availability and labour price when responding. Happy to send photos/details of the existing cooktop and switch before the job if helpful.

I need 11 light switches (6 Single/2 Doubles/2 Triples in bathrooms and 1 4) changed. I have purchased all the complete switches, just need them changed over. I also need a 90m downlight replaced, ideally SAL Wave. I dont have this so would need it provided

Seeking quote to install the 6 smoke alarms. Details: 1. 4 bedrooms and 2 hallways 2. the 2 hallways already have wired smoke alarms (need to be removed and install new ones) 3. install 4 new wireless smoke alarms 4. 2 RFMOD modules setup 5. Electrician should be able to provide certificate Note: I can supply 6 RED smoke alarms. Please see the image.

We have our benchtop being removed prior to a kitchen refresh (painting and tiling, etc). Prior to the removal, we need the electrical supply to the kitchen capped off and power points and oven made safe.

Installing solar floodlight , easily done as no cables but is required up high as in second story please .require high ladder. thankyou

I have a new oven and induction cooktop to be installed. The old appliances have been removed so just new an Electrcian to connect the existing wiring to the new appliances. I work from home so can very flexible if you want to do this between other small jobs or if you are passing through the Nundah area to or from other jobs. I can send more pictures of the electrical drawings in case you will need additional supplies to complete the job. If you have questions, please reach out.

Electrical garden light cable needs removing from our front garden.

Hi there, Looking for electricians to come and give us a quote and get the job done for a renovation rough in. Thanks

We have 7 wired in down lights that need replacing by an electrician.

Hi, I’m looking for someone to install, including ducting for a new rangehood. The rangehood is a Smeg Victoria chimney-style rangehood, and there is currently no existing ducting to the outside, so a new ducted exhaust will need to be installed through eave. It’s a low set one story house. Tasker to provide ducting for room and external vent. There is a manhole for access. Electrical has been completed- they have installed a movable electrical outlet. The rangehood has already been purchased and onsite