Find local power point installers in North Brisbane

I am looking for a licensed electrician to supply and install two external weatherproof double GPOs on the external brick walls of double-brick house. - One at the front of the house. - One at the rear of the house. - Include all materials, wiring and fittings required. - Test both GPOs once installed. The electrician can assess the existing electrical setup and determine the most suitable wiring route and connection to a suitable power circuit. Please provide a quote inclusive of labour and material and compliance certificate.

I would like to install two double power points (one in each bathroom) and replace a faulty stove switch. There is ceiling access. Please provide a quote. Thanks.

Looking for a licensed electrician to supply and install an outdoor weatherproof double GPO on an external brick wall. There is an existing internal double GPO on approximately the opposite side of the same wall, so hoping the new outdoor outlet can be installed back-to-back or nearby using the existing circuit, subject to the electrician confirming suitability. The outlet will primarily be used for EV granny charging, so the circuit and installation will need to be suitable for sustained charging load. Please include supply of the weatherproof GPO, installation, testing and any required compliance documentation in your offer.

Needing 3 power points installed into my garage

Electrical Work Required 1. External Weatherproof Power Point – Repair/Replacement The external weatherproof power point is no longer working and the switch cannot be turned on. The issue occurred after an extension lead connecting an outdoor projector was accidentally dragged into a puddle of water. The connection began smoking, and since then the power point has stopped working. Please provide: * A quote to inspect and repair or replace the external weatherproof power point. 2. Internal Double Power Point – Replacement An internal double power point also requires replacement. The on/off switch has broken off, making the power point unsafe to use. Note: don't need the additional point for the food incinerator as that's no longer connected

Electrical Work Required 1. External Weatherproof Power Point – Repair/Replacement The external weatherproof power point is no longer working and the switch cannot be turned on. The issue occurred after an extension lead connecting an outdoor projector was accidentally dragged into a puddle of water. The connection began smoking, and since then the power point has stopped working. Please provide: * A quote to inspect and repair or replace the external weatherproof power point. * A quote to upgrade it to a double weatherproof power point (two outlets) if possible, as this location is also used for the hot water system. * An inspection of the circuit to ensure there is no additional damage resulting from the incident. 2. Internal Double Power Point – Replacement An internal double power point also requires replacement. The on/off switch has broken off, making the power point unsafe to use. Please include the replacement of this double power point as an additional cost (to consider if needed at this point)in the quote. Note: don't need the additional point for the food incinerator as that's no longer connected

I require an electrician to test a new PowerPoint for a new gas cook top pre install, and to check the power source for the new hood top is compliant.

Need a new power point installed in kitchen. The nearest existing one is 1.5 m away. Plyboard walls. Easy roof access from hallway opening if needed. Single story house. I already have the new power point. Flexible with time. Prefer Friday or Saturday morning if possible. Otherwise sometime next week.

I have a townhouse, built 2022 - shares walls with other townhouses on both sides, steel framed. Need to install 2 new sets of power points. One regular 2x Clipsal in the living room. and one with 2x points and the 10A USB a/c in the kitchen. Attached floor plan marks the needed red power points and the existing blue power points

Hi, we need to install two power points within the ceiling cavity/roof space.

Replace 1 faulty power point in my kitchen; parts to be replaced are to be provided by you (refer to attached image): 1) 1 x Double Power Point w/ Extra Switch - VS 2) 1 x 35A (HOB) Switch Mechanism Labelled HOB - VS 3) any screws/tape necessary, removal of damaged parts Electrician must hold valid license and certifications; Please provide itemised quote for the full final cost of the job, including all costs for the full job (parts, labour, call out fees; clarifying if GST is included or excluded)

Part 1 Wed 20 May: Removal inactive data point boxes and cabling x6 Removal power points from 2 walls Removal old aircon switch at wall Part 2 anytime in the week of Monday 1 June: Install x6 downlights in 1 room with dimmer Install x2 downlights in 2nd room with dimmer Install x1 6 bar spotlight I have the lights and bulbs and dimmers

I got 2 gray electric wires in wall so I need qualified electrician to put power point or switch in there .

Description: Looking for a qualified electrician to relocate multiple power points currently installed under a table/counter. Scope of work: Remove existing power points from under the table Reinstall them neatly into the wall (timber panel) Wall cavity is empty, so should be straightforward access Ensure all wiring is safe, compliant, and properly secured Clean, professional finish required (no visible messy ) LOCATION taigum shop

I need a qualified sparky to come and install 2 power points, one 1 in the lounge and 1 in the room. You'll need to climb in the man hole to access ceiling.

Install PowerPoint inside bathroom cupboard

Disconnect power point so tiling can be done

Replace power points of bedroom and living room (8 provided by me) move internet wiring to another section of living room. Bathroom: Disconnect the bathrrom power points (2) before or on 6th Feb. Come and Rough in once demolition happens on 10th February for power point (2) and three in on light/fan/exhaust, two led down lights. Once sheets and tiles are in, install the products. Move the security camera wiring in the wall in the hallway. This can be done at the time of bathroom rough in.

I’m looking for a licensed electrician to complete final electrical connections. The cables are already run and in place (see photos). I will supply the light fittings power points and switches. Scope of work: Connect existing cables to: 1×Light fitting 2× Power points 1× Switch

I want to install a bidet on an existing toilet for my wife who is very ill I need a power point installed on the tile wall behind the toilet. There is a double power point on the opposite side of the wall in the dining room, which might be useful to link into rather than traverse the wall cavity and ceiling