Find trusted local electricians in Outer South West Sydney

Looking for a licensed electrician to inspect and repair a ceiling light fitting at my house. Issue: -The ceiling light fitting is currently not working. -The light does not work when a light bulb is installed. -Looking for someone to diagnose the electrical fault and repair it. -The existing fitting may need repairing or replacing. Requirements: -Must be a licensed electrician in NSW. -Bring the necessary tools and equipment. -Please provide a quote, including labour and any potential replacement parts. -Ideally, complete the job during the same visit. Photos of the existing light fitting are attached. Please include your availability and estimated cost when making an offer.

I need help to repair or replace a bathroom downlight/exhaust fan combo. The light is not working but the fan is still working as normal

Replace 3.gang switch in bathroom Swap pendant light in kitchen. No parts.

Hello, We have a blown light bulb at our store. We need you to supply and replace it.

EV charger installation for my BYD Sealion 5; the charger needs to be next to the main electrical switchboard.

We currently have a EV charger point already wired in(it was operational for a few years.) we bought a new Tesla Wall connector and would like it to be wired in 3-phase. Conduit, isolators are all in place already. The house already has 3-phase power. Length from switchboard. Approximately, double garage length 5.4m across the top of the garage and about 1.6m down towards the isolator and 0.4m right angle bend towards the isolator Task involves new 3-phase circuit breaker Convert a line to 3-phase. Install charger to wall Wire in the charger.

Looking for a licensed sparky to install 22 LED downlights. Please let me know in your bid if your quote includes supplying and installation. It will be on Townhouse both downstairs and upstairs. Downstairs roof access is not available. Location Glenfield I know it's not $100 job, willing to get your best price.

I have a Westinghouse electric freestanding cooker with four burners. Two burners gradually developed a fault where they heat up to maximum temperature regardless of the heat setting. The same issue has now started occurring with the grill below, where the heating element reaches maximum heat as soon as it is switched on. I’m looking for a qualified electrician to inspect the cooker, diagnose the cause and advise on the most cost-effective solution. I would like quotes for two options: Option 1 – Inspection and Repair - Diagnose and repair the faulty burners and grill. - Check the remaining burners and the overall electrical operation of the cooker. - Ensure the underlying issue is properly resolved to minimise the risk of the same problem recurring. Option 2 – Cooker Replacement - Provide a quote for installing a similar replacement electric freestanding cooker. (Excluding oven price) - Include disconnection and removal of the existing cooker, installation of the new unit, and disposal of the old appliance. - Advise whether replacing the entire cooker would be more economical than repairing it. Please provide separate estimates for both options, including labour and any applicable additional costs. Happy to consider your professional recommendation on which option would be more cost-effective. Thank you!

i want to install kitchen chandelier light

We’re looking for a licensed electrician to replace three existing ceiling fans in a single story house. We will supply the fans and blank wall plates to replace the wall switches. The new fans are remote controlled.

Install 2 pendant lights, wiring is already done and connected to switch. Pic attached. Install double power point, first floor, clear access is available

New light switch and new globes for light

If you do no want to work within my BUDGET or very close to it do not bother to respond you will be wasting your valueble time. need electrician to replace new light sockets and 3 to 5 power points we pay for materials please stop Trolling us....

Hi I have a fox EV charger Need to install closer to meter box 3 phase connection Area Campbelltown Thanks

I have EV charger and i need qualified electrician to install it in my garage. My switchbox is right next to the garage wall, might need to drill a hole and run a short wire. I have 7KW ev charger from my Car showroom and 1 phase @ home. It wont take more than an hour max.

Rewiring of a bunch of 12v circuits on multiple vehicles and plant General 12v work, no license required ongoing weekly work available

I already have the Tesla Wall Connector hardware ready to go. Single storage house with roof manhole access. The installation spot in the garage is under 10 metres from the main switchboard. all necessary wiring/conduit and a 40A Type A RCBO (combined circuit breaker/RCD safety switch). Must be a licensed electrician and provide a Certificate of Electrical Safety (CCEW/COES) upon completion. Let me know your quote. Thank you

Hi, I need someone to supply and replace PLV 500kpa as per photo, the existing one is leaking water consistently. Easy access ground floor property in Ingleburn

Power point is working normally. The front cover/faceplate has come loose and needs to be secured or replaced. Photos attached.

Hello, We are looking for a licensed NSW Electrician to attend our retail store, in Narellan Town Centre, to replace two faulty ceiling downlights. The Issue: Two recessed LED downlights at the front of our store have stopped working. The Job: The task is to replace the two faulty LED downlights. The scope of work includes: 1. Safely accessing the light fittings in the ceiling (a suitable ladder is required - ceiling height: 3.5 meters). 2. Diagnosing the fault for each light (e.g., failed LED unit or faulty driver). 3. Supplying and installing two new, suitable replacement LED downlights and/or drivers. 4. Ensuring the new lights' colour temperature and brightness match the other existing lights. 5. Testing the new lights to confirm they are fully operational. Requirements: - MUST be a fully licensed and insured NSW Electrician. - You must have your own tools, including an A-frame ladder appropriate for a standard commercial ceiling height. - The contractor must be able to supply two standard replacement LED downlights and drivers. Location & Timing: Location: Narellan Town Centre, 326 Camden Valley Way, Narellan NSW 2567 When: The job can be completed at your earliest convenience. Please state your availability in your offer. Please provide a comprehensive quote for the complete job. Your offer should include all labour costs AND the cost of supplying two new standard LED downlight fittings. Thank you.