Find a local electronics repairer in Outer South West Sydney

Fix 4 leaking bathroom taps, install 1 x new toilet seat, stop 1 x running toilet cistern, 2 leaking showers

I recently bought and moved into a house and I am needing assistance in the new laundry. My partner connected our washing machine to the current taps located in the laundry but they were leaking. We would like replace the taps/plumbing as needed and also move the taps lower down on the wall so that we can stack or hang our clothes dryer on the wall above the washing machine. I understand this means cutting into the wall etc and will come at a higher cost than what I’ve put on here, will need a quote done after assessing etc. If either my partner or I need to be home when you visit then we can only do weekends, or if happy to come by yourself and communicate with us via phone / text we can give you access to the house with our lockbox.

We have a sewage / rotten egg smell coming from the shower floor drain in the upstairs bathroom of a two-storey house. The shower is only used occasionally. There is visible water and some buildup inside the drain. We need a licensed plumber to: * Inspect the shower drain and identify the cause of the smell. * Check the water trap (P-trap), trap seal, drainage connections and possible venting issues. * Clean or repair the drain if necessary. * Resolve the smell, not just temporarily mask it. Please bring the necessary tools and aim to fix the issue during the visit.

I have a 1970s Onkyo X-3 4-Channel Surround Stereo System (integrated amp/receiver) that produces a loud, low-frequency hum when powered on. Hum is constant and unaffected by any front panel control (volume, bass, treble, balance, etc.) Hum remains identical regardless of which input is selected (Phono, Tape, FM, AUX) No cables are plugged into any RCA inputs — hum persists even with nothing connected Likely the aging electrolytic capacitors in the power supply that needs a recap though I'd welcome a proper diagnosis from someone experienced with vintage hi-fi equipment.

Need pest control to exterminate and control wasp nests around the house. Small wasp nests all around outside (roof, walls and under gutters) and also have seen wasps inside the roof void.

2 stumps need grinding, plus the roots. The big stump is half rotten. If the smaller stump is too high I have a chainsaw to cut it down smaller. The entry to the backyard is about 1400mm so there is a size limit.

Send quote: I’m looking for a qualified installer to fit side steps (running boards) on a Renault Kadjar 2020. 📍 Location: Currans Hill 2567 🕐 Date & Time: Friday October 30 10:00 am Please provide your quote and confirm your experience with similar installations. Thank you.

Need the removal of all garden hedges & stumps. This will include taking all the rubbish as well.

Need to fix Harmon Kardon Amplifier model avr151

Head unit is working but no sound coming out off the speakers. Might be a short circuit. I think the amplifier got this issue due to moisture content in the trunk around the amplifier.

Concrete Floor for walkway to painted, and touch up paints on doors and walls inside thehouse ( Looking for Day rate for 2 days works)

Have around 17 colourbond panels need to be recoloured to match the other side in Grey. Looking for supply and spray options Only spray my side of the fence

Need to install two taps on our new kitchen benchtop. The water lines and pipes are already in place; they just need to be connected and set up.

I need holes for taps on my vanity stone top ,so we can connect taps .

Removing 2 tree stumps from my property and disposing the debris. One is a Muraya tree and the other one is a lemon tree

Interior Touch-Up & Painting: Garage, Under Stairs, Walk in ceiling, and bathroom. Painter needed for small touch-ups and specific areas (Garage, under stairs, bathroom, walk in closet ceiling)

Remove two tree stumps approx 70cm height.

Remove stumps and roots of multiple trees in the back yard. 16 stumps in total Clear leaves and rubbish, tidy up the yard.

I just need to replace 7 wooden steps of the staircase.

I need navman cruise650mmt usb soldering back on circut board. Already removed.