Find trusted local electricians in Blacktown

I need quotes for replacing downlights and happy if someone wants to visit before giving a quote.

Looking for someone who can check solar panels as it’s not producing

20amp rcd and mounting bracket supplied, 2.5mm twin and earth cable already in the electrical box, just needs to be wired up. The new circuit is for roller shutters in the house. All other connections are done and the end of the circuit is capped off and within a junction box. Zero cuts in the wiring it's all 1 x 2.5mm twin and earth and the corrections are made with correctly rated quick connects and factory supplied cables with 10amp 3 pin plugs.

We have 9 frisbee disc lights installed across our 3 bedroom house and would like whole house replaced with downlights. (Kitchen, dining, laundry, living area, stairs, hallway, x3 bedrooms)

Need an electrician to fix two lights. Please see photos

Install a new power point in garage ceiling to power the autmatic door opener.

I require an electrician to install three sensor lights on poles, 3x25 meters apart (approximately 75 meters length), leading from the granny flat along the fence including underground cabling for night visibility of pathway (photo 1 shows required spacing marked in red). Please note: only poles and lights will be provided for the job.

MCB tripping on turning heater on.

Replace downlight simple task

i need 2 downlights in each room, there are 4 rooms

Need a licensed sparky to install a Shelly Pro 3EM-3CT 63 (3-phase energy monitor) into my residential switchboard this Saturday. The job: Install 3 × split-core CT clamps around the 3-phase mains cables between the meter output and main switch Mount the Shelly Pro 3EM unit (DIN rail or adjacent) Wire a 240V AC feed to power the unit (from a spare MCB or existing circuit) Verify it powers up and CTs are reading What you DON'T need to touch: The Endeavour Energy revenue meter (Elster A1100), sealed, stays as is Service fuses Solar inverter or array wiring Any existing circuits What's already here: 3-phase board, dual supply (grid + rooftop solar) Elster A1100 meter, Endeavour Energy network Tenby Cables switchboard, Left + Right modules The Shelly unit and all 3 CT clamps — I have everything, just need it installed I'll provide: Full installation guide with wiring diagram (already prepared) Photos of the switchboard for your reference (attached) The Shelly Pro 3EM unit + 3 CT clamps (all supplied) You'll need to bring: Short length of 35mm DIN rail if there's no spare space on the existing rail (board looks fairly full, may need to mount a small rail segment on the back panel) 1 × MCB (6A or 10A) to protect the Shelly's 240V power feed Short lengths of wire for the 240V feed (L + N to the unit) Location: Kellyville Ridge, NSW When: This Saturday — flexible on time, morning or afternoon Budget: $150 – $200 This is a straightforward install, no modifications to existing wiring, no meter work, just clamp-on CTs and a small monitoring unit. Should take 30-45 minutes for anyone familiar with switchboard work. Must hold a current NSW electrical licence. Happy to see your licence number before confirming. Cheers!

Install the light to the ceiling

Need to replace 2 Switches and 1 x 3 Gang. All materials supplied. Just need expertise to replace them.

Hi I need a replacement of 4 light switches and our bathroom exhaust has stopped working. I have only put $10 as budget can be discussed. Location is Blacktown NSW 2148.

Replace 16 x downlights - will supply new downlights

I need an electrician to add some extra electrical points 5-6, install new lights (5-6) both internally and externally. Please quote your hourly rates.

Need a licensed electrician to supply and install a smoke alarm (prefer brand clipsal). The current one which needs to be replaced is a hard wired with 9v backup battery smoke alarm.

Please note that this is a double storey house. The power outlets have already been purchased from Bunnings and are available on site. This is a new installation, so there are no existing outlets in those locations to replace. The roof space is accessible. I would like the work to be completed by Wednesday this week

Small drip coming from the tempering valve on the hot water heater.

I want to get downlights in garage and install two cieling fans in two bedrooms. Also install outdoor lights