Find experienced local carpenters in Greensborough

I have an old kitchen that needs 9 new cabinet doors and 4 drawers, modern off white, flat look, gloss, various width, 74 cm high, soft closing hinges. Installation as well.

I have 2 kitchen cabinet doors that need replacing - just the same off white doors. One cupboard is a corner cupboard. See photos

Clean and stain deck 3.7m x 7.5 and seating areas. We can provide Cabots deck stain if preferred.

I would like to change the wooden frame in the kitchen window

I have a block of Blackwood (approx 1400 x 600) that I would like to use as a dining table. Picture attached. I am looking for someone to fill the small holes with an epoxy, sand it back and finish it. I’m thinking satin water-based polyurethane but I’m open to suggestions if something else would be more suitable. I want it to be durable and very smooth.

Carpenter needed for lock up to make it ready for plaster. The floor plan attached.Its 16square house. Needed two bulkheads one for drainage pipe going to first floor and 2nd bulkhead for air con duct going to first floor. The flooring has been completed.Must provide invoice with their ABN.

Hi i am looking for a carpenter to help me redo a brand new timber frame for the front door, and install the door as well. No need for lock installation. I can provide the door if can tell me the size to go for. Please see measurements in the photos, my measurements could be off. Happy to re-measure to meet the standards. Door size roughly could be 1200X 2040. Need the job done ✅ somewhere in Sep depends on your schedule. Thanks

Need carpenter to fix the following: 1. Bathroom door- The door is not closing and getting stuck. it seems like the rollers are jammed. It would be good to replace the rollers.

The timber frame on couple of our windows has been damaged due to age and weather. We need someone to fill holes and reseal the frames on various windows.(about 4 to 5 windows)

Supply timber and build flat tray in Toyota landcruiser, Seal timber. Would think something like Jarra flooring would be good?

My brother and I were assembling an IKEA cabinet. Due to human error my brother attached the backing board to the front of the cabinet. This job would need to be done very carefully but someone with experience will find it easy.

Need help with decorative partition between living and kitchen and a temple made.

I’m looking for someone to remove this tire wooden storage shelf section from the back of my garage so that I have more room for a power rack.

Install kitchen and 2 cabinetsin laundry,all with side panels and infills. cabinets already screwed together, need to be positioned and secured. Fix price quote only, experienced installers only.

looking for a carpenter to install one vent about 4mx11cm height. the timbers needs to be cut in order for the vent to fit.

I have a timber window with an Aluminium vertical slide. I would like to replace the vertical aluminium window section within the timber window frame. The existing vertical slide is 2 Panels and the overall size of this window is 1290h x850w. No header & sill glass . Glass into rebates cut guides 25mm. Note, I have about 6 like this that I would like to replace

I need an experienced carpenter or kitchen installer to modify an existing kitchen cabinet to allow installation of a standard under-bench dishwasher. The job involves: - Removing/cutting out the base panel of one cabinet so the dishwasher can sit on the floor - Keeping cabinet sides and structure intact - Neat, square cut - Sealing exposed chipboard edges to prevent moisture damage No appliance installation required — cabinet modification only. Photos available (see attached). Location: Greensborough Preferred experience: Carpentry, kitchen installation, or cabinet modification experience. Timing: Flexible — preferably within the next week. Open to quotes.

I need a person with carpentry skills to replace three pieces of facia timber around my house and garage. I also need three window sills replaced. They will need to be replaced with hardwood timber.

Cut pieces to size (not already correct size) and fit 2400x900x33 timber bench tops for kitchen as per pics and as required. 3 x benches have no cut outs and 1 x bench needs a kitchen sink cut out.

- Measurements - 7m2 - Old decking to remain on site - Need labour and nails