Find an experienced builder in Inner South Melbourne

Rotting pergolas needs restoring / re building. Looking for a qualified carpenter who takes pride in their work and pays attention to detail. Looking to arrange in person quotes.

Need to replace the 7 year old pergola roof with a new one. It is located on the back of the house.

Build this flat pack sauna https://www.luxoliving.com.au/lue-2-person-full-spectrum-curved-infrared-home-sauna It’s in 3 boxes

Oil stain on our blue stone driveway, need someone with degreaser and a pressure washer

The bottom of one double swing driveway gate is damaged - metal frame and the drop bolt got bent. Can you fix it? If we need to replace with new ones, please let me know how much!

Add 4-5 polycarbonate sheets to cover the open area of existing pergola. And add Bunnings bistro blinds on the left.

Hi there, I need help with dismantling a small shed (approx. 2m x 3m), transporting it and reinstalling it at another property 2.5km away (next suburb). The shed needs to be carefully taken apart, moved, and reassembled at the new site. 🔨 Job Includes: Dismantle existing shed Transport shed panels and parts (you’ll need a ute, van, or trailer) Reinstall shed at the new location on the ground/crushed rock Ensure it’s stable and properly aligned 🗓 When: This week – preferably before Sunday. Flexible with day/time. 📍 From: 3195 📍 To: 3196 – same area, 2.5km away Requirements: Experience with shed assembly/dismantling Own tools Suitable transport Reliability and care with handling Let me know if you’re interested and available. Thanks!

Want a licensed builder to knock down a 1800mm internal wall between kitchen and living area. This is a load bearing wall on a ground floor double brick apartment with one apartment above it. - Engineer drawings and calculations available - Body Corp approved - building permit in progress Scope of work: - Carefully remove approx. 1.8m section of a load-bearing wall as per engineering specs - Install structural support - weld additional steel plates with holes to the bottom of steel beam (for a pendant light) - Coordinate with me and other trades necessary - Ensure site is safe, clean, and protected during and after works (includes clean up) Also looking for carpentry for archway and plastering if available afterwards. If you want to inspect first please bid as low as possible. Open to all offers :)

New pailing fence 8m x 1.95m, 3 rails and bottam plinth. Remove exiting pailing fence.

A true carpenters or enthusiasts dream job! We need a full cat enclosure built. The area is 2metres by 2metres... The area has three walls and needs a fourth fence built with a large entry door for a human and also will need a wire roof and a gap blocked at the 2 back corners

Install shed to underground car park

I need this area excavated and soil taken away. 150mm deep 7.2x3.8 Mentone

Small size 1.7m x 1.9m No bath (shower, vanity and tiles). 4 walls plus floor only. Ceiling not required. Tiles, shower, shower base, vanity, mirror, toilet all to be removed. Rubbish removal also needed from site

Removal of an existing shed and shed concrete slab. Shed is 3.6m x 6.7m. Side access is 2.5m down side of house. Must include slab removal

My driveway has two spots where the pavers have sunk. Both around 75cm across. One of them is quite deep around an inch or two, the other is very gradual and not much of a problem. Would like a quote to fix just the bad one, or both. Would be looking for someone with experience in this job, making sure to have the tiles perfectly level with each other to prevent tripping hazards.

Hi my driveway gate needs to be fixed into the hinges and the bolts need to be screwed back.

Assemble two sheds- images shown. Onto pebble rock surface. Would like done asap

Fixing a Metal gate that dropped about half a cm need to fix the hinge by welding it back on

Need some advice on some house renovation work in the bedrooms and also need advice in removing the top part of a metal chimney from the roof and ceiling. Looking for 40 minutes of a registered professional builders time to talk through what I am thinking and get their advice on the best way to proceed. Builder will need to look in the internal roof space to check some bits. Easy access inside and I have a ladder. Happy for quotes if they also wanted to offer their services for bits of work.

Assemble a garden shed (that I've purchased from Bunnings) on a pre-existing concrete slab in our backyard, picture of location and shed type attached. Dimensions = 2.3 x 3.0 x 2.3m Front Gable Single Sliding Door Shed. Task instructions: 1) Review shed MODEL: 30302GK instructions on the Absco sheds website. 2) Bring a power drill for tightening screws, eye protection, hammer and philips head screw driver. (I will provide a 2 meter ladder) 3) Assemble shed, I work next door so can come and help hold bits at key moments if required. 4) Clean up shed package materials into our recycling bin (There is a place to safely park your vehicle and you are welcome to use the church toilets (next to our house) during the job.) We have guinea pigs in the back yard, so no dogs please, sorry.