Find wood fencing professionals in NSW

Driveway wooden gate, the hinges need to be repaired. The hinges attached to the metal upright post needs to be welded back on.

Metal Posts are already installed. Just need hands with installing the pailings and reorganising the fence

Want to build a wooden gate and fence that spans about 3.5 meters between house and boundary fence (about 1m wide gate and 2.5m length of fence). The gate should be offset to the left/house side, and then fenced up to the boundary. I want the slates (85mm spotted gum to match existing decking with about 3mm of spacing) to run horizontally. Yet to decide on the height of the gate, but thinking between 1m-1.8m high. See attached photo where I've installed a temporary gate. Quote should include materials and labor.

Remove 35m brushwood fence along boundary line

Pull down old wooden fence and some small shrubs and replace with traditional brick period style fence with modern wrought iron gate and panel Remove rubbish and green waste. Dimensions. 3.5 m x 1.5 m standard height

Remove rotten wooden fence and some plants along fence. The replace with brick traditional low fence with modern wrought iron gate and insert. Will need to remove old waste and green waste. Dimensions. Total length 3.5 mt x 1.5 mtr. See photo for idea. See pics of old wood fence and also pics of what I’d like to replace it with

Replace small wooden front fence easy access with a very similar wooden fence will need to dismantle and remove old fence. And also remove some ferns etc from along fence Dimensions. 3.5 mt length x1.5 deep and 1.8 high. Can use existing wooden gate.

To replace an existing wooden paling fence which is approximately 7.5 metres long , with the same type and size of fence.

Install 2 new wooden fence posts (1 is 2130mm above ground and the other 1700mm above ground) and 2 runs of pailings 1 is 2550mm wide and the other 2490mm wide. The panels follow a slope and are on an angle.

Hi there, Our rear fence has fallen down in the building & we are looking for someone to remove the old fence & install in its place a new timber fence with reinforced galvanised posts. I believe that 2 posts are already cemented & present. Specs: - Approximately 25m Width x 1.5m Height H3 Treated Pine Single Paling (Chipped Corners) Fence with 50x50mm Galvanized posts * Galvanised Posts to be set in concrete * The fence will have 2 horizontal rails and all brackets, nails and screws will be galvanised * If Core drilling is required for Post Holes - NO EXTRA CHARGE - Removal and Disposal of Old Fence Address for inspection of property is: 45-49 Gladstone St Kogarah NSW 2217 There is an alley in the rear of the building with common property, so feel free to come any time and take a look if needed. Cheers, D

Plastic cover to block rain has come undone in wind. Just need it reattached.

Current fencing fell down, posts rotten. Need to be salvaged as the palings are in good health. Or now one perhaps based on site assessment. UPDATE: I have erected the fence with supports to keep it in place. Pls see new photos - the last two. The TASK now is to provide galv posts set in concrete and set the fence in place. The fence is approx. 25 m long. The Task value is thus updated and request for revised offers. THERE ARE TEN POSTS.

Looking for someone who can supply and install wooden fence in a property. Approximate length of fence is 27metres. Location Asquith.

1 of the 3 Post in front of the house was detached due to an accident. The post is half brick half wood (top) and was attached to the ground by a metal rebar.

A very small section of the wood fence needs to be heightened. Simple wood structure required to make sure it is 1.8m from the top of the pump box.

Our wooden gate has been damaged; the frame has come undone. It needs rescrewing and reseating against the fence line. The hinges etc are ok - just needs to be reattached

Replace several wooden pailings on front gate, replace latch, paint gate heritage green to match fence.

I have about 20 holes in Brushwood Fencing that I need patched. The holes are caused from dogs and foxes. I need the holes patched with brushwood or alternative. The Patch only needs to last about 12 months until the entire fence is replaced. Attached are some example photos. Job in West Pennant Hills

From cyclone, fence has fallen down, need someone to fix it or replace it , 7.2 metre approximately 3 panels.

Hello -- we have a Houdini dog who can climb fencing so need a top layer applied to approx 15metres of our external street facing wooden fence. Needs to be no gaps remaining when done. This is very important. Dog is currently locked in courtyard until we get this done so ASAP would be fantastic. You will need to supply the below yourself which is included in total fee 1) From Bunnings https://trade.bunnings.com.au/jack-90cm-x-30m-heavy-duty-chicken-wire-netting_p0027953 2) Nails/hammer. Nailgun would make this a quicker job if you have one. Pictures show entire fence however its only approx 5 1/ 2 sections and from middle paling upwards. Can be placed over the top of hedge although a light prune of leaves coming through side of fence may make it a bit easier - not essential though. Thankyou