Find a professional pergola installation expert near you

Established deck approx. 3x 4.5m, no longer completely level, but remains stable - about 10cm off ground. Currently a Bunnings modular decking wood base - built about 5 years ago. Also need aluminium pergola assembled to go on top of deck, properly anchored, approx. 3x4m.

To dismantle timber pergola safely roughly about 7.8mx3.8m and also straight line clean cut and remove concrete slab roughly about 8m x 2.6m

Sanding one side of a front door then paint it. The other side and door frame are overall complete. There are small areas on the other side of the front door that require a 2nd coat. Laundry door is painted but has a few small patch areas that need a coat. Also painting a 12m x 7cm x 3cm piece of timber on the ground. All paint is supplied.

I need current pergola to be modified to a smaller size The current measurements are 6.5x9.8 and that's from the wall of the house, eaves are 340 to the outside of fascia. The new dimensions need to be 4.8x7.8as a maximum. It will need to be trimmed both in width and length and I believe all the materials would be reusable.  I’m presuming you’d take off approx 800 off of each end of the gable and then cut the length end and bring that inwards ( disposing 1 post ) and bringing the end face in by approx 1.9-2m 

Need someone to have a look at my pergola and possibly fix leak around the fascia between panels The panels are trim deck and I believe the panels were not folded during installation. It possibly needs sealing

My pergola is leaking, I need to get it repaired and get the gutters changed/cleaned

Need a rotting pergola removed from my premises, has had a 'quick fix' done to it but not in good shape. Would likely be able to cut wood into smaller pieces and dispose of in my bin instead of removing waste, not sure what is the cheapest option!

Remove two wooden pergolas and seal the small opening with silicone.

Supply, cut to shape and install.

Need a licensed electrician to complete an outdoor pergola heater connection at a residential property in Tarneit. There is already dedicated electrical wiring running from the main switchboard to an external junction box. The job involves connecting from this junction box to a new outdoor power outlet suitable for a 15A plug-in heater. Key details: Existing dedicated cable already installed from switchboard to junction box Need supply connection from junction box to new outdoor weatherproof power outlet I already have a 15A power outlet available (if suitable for use)

pergola roof sheets replacement in south morang. quote for labour only. i will need you to come with me to order and pickup the roof sheets from closest Bunnings. area 7x4.5 meters roughly

Looking for an experienced handyman or roofing contractor to replace the clear roofing sheets on my pergola. Scope of work: Remove and replace 8 clear polycarbonate/plastic roof sheets 2 sheets approximately 5m x 70cm 6 sheets approximately 2.4m x 70cm Replace 1 downpipe (exact measurements will need to be confirmed on site) Clean out the pergola/gutter while carrying out the work

Looking for someone handy to jack up the corner end of my pergola and screw it back into the existing bracket but slightly higher. The gutter wasn’t draining so I thought I could do it myself, I got one bolt out and it dropped so I can’t get the other one out and it’s way heavier than I expected.

Pergola at the rear has a leak. Size is ~2.8x4.1. Material: colorbond

Looking for someone: Demolish the pergola - remove roof sheets, timbers, fully remove posts from ground, cut roof sheet into half. Move timber and roof sheets 25m to the front of the house for future council collection (unless you would like to have them) 2.4m x 1.9m x 2.2m high Shed slab - break it down into bits and leave it in place. 0.9. x 1.7m x 100mm Electricity is available Preferred dates 27th or 29th may Or weekend 30th 31st after 1pm

I am wanting to have my 43 inch tv mounted to a brick wall outside under my pergola.

Help with the design, supply and installation of a 2.4 x 2.4 paint grade treated pine freestanding timber pergola while my wife is away for business.

Base coat pillars and beams - supply render - base coat only Angle beads installed already

A plastic panel of pergola roof has been dropped. It needs to be put back.

Looking for experienced installer/tradesperson to assemble and install a freestanding motorised aluminium louvre pergola in Glanville. Pergola has been imported as a complete flat-pack kit and includes: * Motorised louvre roof * Aluminium frame/posts * Remote control system * Side screens/blinds Size approximately: 6m x 3.2m Installation details: * Freestanding only (NOT attached to house) * Installing onto existing concrete slab * backyard access * Assembly and anchoring required * Electrical connection can be completed separately by licensed electrician if needed Looking for someone with experience installing: * Pergolas * Patios * Louvre roof systems * Outdoor structures * Aluminium kit systems Please respond with: * Photos/examples of similar installs * Relevant experience * Estimated labour cost * Availability Would prefer someone confident working with imported flat-pack pergola systems. Located in Glanville, Adelaide.