Find a professional pergola installation expert in Inner West Sydney

I am looking for an experienced handyman or roofer to replace the old, dirty polycarbonate sheets on my outdoor pergola. We are preparing the house for sale and want the roof to look brand new and clear Scope of Work: Remove & Dispose: Take down the existing dirty/damaged twin-wall polycarbonate sheets and take them away (Rubbish removal required). Install New Sheets: Install new standard clear corrugated polycarbonate sheets (single layer). Final Check: Ensure all sheets are securely fastened with roofing screws and the area is left clean.

🛠️ Airtasker Job Post — Motorised Pergola Repair (Russell Lea) Task: Repair motorised louvre pergola (jammed + uneven blades) Location: Russell Lea, NSW Timing: ASAP (today/tomorrow preferred) Budget: Open to quotes Description: My motorised louvre pergola has become jammed while partially open. The blades are not rotating together, and a few appear misaligned or stuck, suggesting a pivot arm or linkage issue rather than a motor failure. The motor still attempts to run, but the blades don’t move properly. Looking for someone experienced with motorised louvre roofs, Vergola-style systems, pivot mechanisms, or opening‑roof repairs. What’s needed: • Inspect and diagnose the mechanical fault • Realign/repair pivot arms or linkage • Check motor + gearbox • Restore smooth open/close operation Please comment with your experience and availability. --- Photo 1 C “Pergola blades stuck mid‑rotation — system jammed and not opening/closing.” Photo 2 Caption: “Uneven blade alignment — likely pivot arm or linkage issue.” Photo 3 Caption: “Close‑up of jammed louvre section — blades not rotating together.”

Existing pergola roof no longer opening and closing. Not sure if I need a new remote or there's some other issue...

I would like someone to construct a small awning / pergola down the narrow side of my house to store my bikes out of the rain. The structure would need to attach to the side of the house. The long side of the awning would be attaching to a modern Hardie plank weatherboard clad wall, whereas the short side would need to attach to double brick. In the diagram below, the res depicts the structure I'm requesting to be built. Dimensions would be 5.2m by 0.9m. It would need to attach to the house at about 1.9m above the ground with a gentle slope so the rain could run off (no need for a gutter). So likely to need brackets and some support frames to then hold up something like a Suntuf polycarbonate clear plastic roofing. Please see photos of the area in question and aerial sketch. I would be keen for someone to inspect the site so we can discuss best design & materials before purchasing the materials. The main discussion points is probably whether it would require a support post at the near end. Im happy to either purchased myself or you can, but either way I will fund the materials so please don't include those in your quote.

Hang outdoor lights around pergola and in 2 Smaller trees and around a jacaranda tree stump. Completed by 4pm tomorrow. But not before 12pm start.

Assemble a small IKEA pergola.

Installation of 8 sheets of polycarb sheeting on pergola. We have a small outdoor pagoda (305cm x 350cm) that has recently been repainted. We have 8 new sheets of poly-carb roof sheeting that we would like installed. It requires ladder and drill with hex bolt bit (but we can provide all of these items). We are flexible with date/timing for task but conscious of limiting noise for nieghbours so anytime between say 8am-7pm Monday - Sat. Job estimate is 2-3 hours approx.

Need a simple pergola built - similar to the picture. Need to supply all materials and tools. Need it built before the 19th of November. Price is for a measure and quote only.

We're after a quote on a pergola approx 7m x 4m, supply and install

We want a pergola fixed to the laundry which is at the back of the house.

Need shade cloth fitted to a pergola neatly and professionally. Shade cloth and fasteners supplied. You will need to bring tall ladder(s). This a straight forward job, shade cloth just needs be laid across exisiting structure.

I have a 3m x 2m aluminum frame and polycarbonate pergola kit that needs to be installed at my house. The kit has full instructions. At least one post base will require being concreted.

I'm looking for a licensed electrician to install simple outdoor lighting in a new pergola, as well as one external power point on the wall. Details: Pergola will be newly built (by a carpenter) Lighting doesn’t need to be anything fancy – just a cost-effective solution for evening use One outdoor power point to be installed in a nearby wall Property is in Concord, 2137 Timing is still to be confirmed but I’m looking to lock in someone who’s happy to coordinate around the builder’s schedule Please let me know your availability, estimated cost (including materials if possible), and any questions you may have. Thanks so much!

I have a pergola but it’s not to council standards so I need some one to come n have a look n tell me what needs to be done so I don’t have problems with council

Assemble louvred pergola 4x3

Remove old poorly built pergola and frame new pergola in place of it ready to have new roof attached

Install a ceiling fan on the pergola. Need to run the cable through the pergola and mount the fan on the pergola ceiling

I need this pergola to be assembled https://cosydeals.com.au/products/aluminium-pergola-gazebo-3x3m-13

Please build covered pergola

Remove leaves from pergola roof, clean gutter near pergola, install a door handle, hang a mirror