Find a local Tasker to help you make a kitchen cabinet in QLD

Task for handyman/carpenter/apprentice To reaize this long cabinet to reclaim more slab space back for use. Happy to give a hand if needed Flexible with day and time

4 melamine cabinets 600x600x300 deep (either from bunnings or ikea) installed on the wall about 650 above an existing kitchen benchtop and stove. End cabinet will contain a range appliance.

Existing dishwasher cabinet has pulled out little bit and not aligned with other existing cabinets

Would like to get our kitchen wooden cabinets, doors and draws painted in 2 pack paint or something that has a similar affect, or what would be recommended.

I want to repaint my kitchen cupboard doors but don’t have time. Would like the job completed by Christmas. Space onsite for working and all materials and basic equipment available. There are 12 doors lower cabinet doors, and about 10 drawers and 1 set of pantry doors.

Need new top cabinet added to existing cabinets and 4 custom sized doors to all to ceiling height

I would like a pull out pantry cupboard transformed into shelving with door

Replacement of drawer fronts and doors in kitchen. Position of drawer runners will also need to be adjusted. Materials are supplied for drawer fronts (4) and doors (3). However they will need to be cut as they are too long for the drawers and pull-out doors. The material dimensions are as follows (but will need to be cut to length) Door fronts (2): 30 x 80cm Door fronts (1): 60 x 80cm Drawer fronts (3) 40 x 20cm Drawer front (1): 40x 10cm

Install Renovators Store 450mm sliding kitchen bins into kitchen cabinets

A tall pantry like cupboard with same or similar cabinet board which need to be purchased

I want one of the side panel and shelf removed from my kitchen cabinet to accomodate a slightly big refrigerator.

I have a 15m strip of 22mm wide pvc edge trim for kitchen cabinets. I need to cut it down to 16mm wide but don't have the correct tool.

I want to get a dishwasher installed and my existing kitchen cabinetry needs to be partially removed to accommodate it. There is currently a large cupboard with a single shelf and a door which needs to be removed somehow, ideally without compromising the rest of my cabinets or countertop. Dishwasher installation is NOT required, only the cabinetry modification.

Have installed IKEA method kitchen cabinets. Need a cabinet maker with keen eyes to advise me if the cabinets are levelled enough for the kitchen countertop to be installed. Quick money just to spot check and confirm but happy to pay variation if further levelling is required. Flexible on dates but needs to be done before Saturday as this is when the stonemason will be out.

I’m looking to install a dishwasher in my granny flat and need someone to come in and do some modifications. I’ll install either a full sized dishwasher OR a benchtop dishwasher by removing the two bottom drawers. Not yet sure to be honest and I’d love your advice. I’ll buy the dishwasher beforehand. I’d like to get this done before October 2nd Please quote your labour and the cabinet fillers

I have a partly installed kitchen and need some help rearranging a couple of the cabinets and levelling the bases. This isn’t a full kitchen installation job, just need up to 4 hours to arrange these so I can get counter tops measured up. Must be done this weekend or possibly tomorrow Friday. Preference for a cabinet maker but carpenter or handyman also ok.

My kitchen cabinet doors are not closing, due to the sliding rail mechanism not locking when pushed in. About four draws need fixing.

Hello I need my stone benchtop removed from my cabinets tomorrow I had someone lined up for today but they cancelled last min and I have a measure up for new bench Friday morning

Build my IKEA kitchen cabinet. No install and no doors/fronts. just build the base cabinets. 1 x set of drawers, 3 sets of cabinets, one cabinet with pull out

Looking for someone who can cut and Install Filler piece above oven