Find an experienced handyman in Wynnum

Carry out minor panel repair to car

Cut and install kickboards in kitchen. 2 x pieces >1m 2 x pieces <1m strip ~7mm off of each length

I'm looking for someone who can install one the garage screen doors here https://lifestylescreensau.com.au/ Ideally someone with experience installing these particular doors but where are YouTube guides on how to do it so a decent home handyman could probably do handle it.

3 internal doors cut to size and hung including handles. I have purchased the doors and handles. Patch a big and smaller hole in hallway wall.

just glue, patch and touch up paint, don't worry about the door handle

Lift up and over balcony.

We have a recently installed Mitre 10 (principle Kitchens) lazy Susan cupboard where the door falls of or the door hits the top internal bracket when turning. Needs to be inspected and repaired.

Install outdoor blind to a window. I have the blind just need someone to put it up. I would also like to get stronger screws for it as the screws that come with isn’t very strong.

Replace cords on 2 venetian blinds.

Please see pics attached. Need someone to fix small dent and remove scratch marks

Install security doors which are already purchased

There’s about a football size hole in my drywall and a small crack/indent I need fixing as I have an inspection on Tuesday.

3 x dining chairs needs repair. The ratten section has broken and needs fixing. We don’t have extra ratten and will need this to be provided too. Thank you :)

A hole was cut in the wall to test for mould, which needs to be plastered up.

Need someone who will be able to fix this mailbox. Might need a new mailbox top.

Put a blind up in the kitchen. I already have the blind.

Disconnect and remove existing motors from the rangehood before installation. Install the supplied Qasair Lismore triple motor rangehood, fixing it to the overhead cupboards. Supply and install a Qasair triple motor custom TMT fitting to offset the outlet by 200mm, avoiding ceiling rafters. Supply and install approximately 13 metres of apron flashing on the roof (approx. 900mm wide), running from the top ridge cap down past the rangehood penetration to the gutter, in Colorbond Wallaby. Measure, mark, and cut a hole in the plaster ceiling to suit 350mm round ducting. Measure, mark, and cut a hole in the roofing sheet to suit 350mm round penetration. Supply and install 350mm round ducting and a backdraft roof cowl with Dektite to suit the penetration. Complete all roof works and seal the penetration. Test the new installation to ensure functionality.

As discussed. Hand rail and balustrade.

White timber internal shutters - some have missing louvres or broken mechanisms that open and close.

Back stairs and back ramp need some work. Things are loose and wobbly. The timber is soft in areas. We need to replace two hand rails and balustrading. Look for an economical option here. https://www.bunnings.com.au/peak-aluminium-balustrade-1000mm-white-deck-stair-post_p0220787