Find a professional gate installation in Inner West Sydney

We want to install a remote operated automatic gate at the front of our house. Ideally Bifold gate with motor attaached to the door so it doesn't take extra space. Or a sliding door. If it can curve into a back wall, would be best. If not, open on a hinge. Since its a small driveway, i would hope you can do this without taking too much space from the driveway. You would be expected to supply and install the gate. Build the side fence to accompany the gate for the entire entrance is blocked. Note: Electric connection not available so needs to be brought from the house (approx 20 ft).

I’ve installed a new two door swing gate and need the closers reinstalled. Also need a new mounting bracket and one pin as shown.

We want to install a remote operated automatic gate at the front of our house. The door should be sliding door. If it can curve into a back wall, would be best. You would be expected to supply and install the gate. Note: Electric connection not available so needs to be brought from the house (approx 20 ft).

Need an experienced DiTec automatic gate specialist to troubleshoot a problem with automatic gates. System is an old DiTec E2 dual motor swing gate. Gates will not open or close properly. * Remote button pushed, gate initiates open procedure then stops after a few cms.

Gate doesn’t open or close when remote button is pressed. No debris on the tracks or anything inside the motor box. Assuming motor is stuck in manual mode. Need a key to Unlock it. - Due date: Flexible

**REPAIR SLIDING GATE MOTOR** Have an auto sliding aluminum gate, with a FAAC 740 motor that has stopped working. Need to repair the motor and get it back in working order. Photos attached - Due date: Flexible

Install a fence with a gate and 2 timber gates on 2 sides of a house

We have 1m wide gate that is very sticky and requires more effort to open and close than it should.

Make Custom timber side house gate - including material supply Carpenter / airtasker to supply timber and hinge materials Side gate: Opening 1200mm wide 1800 high Entry gate 920mm w 980mm H Unpainted Maker to provide hinge hardware and hang gate in existing brick opening Gate to have manual access code entry hardware - provided by owner / us - Due date: Flexible

Handy person required to fix timber gate that no longer clicks into its latch as the gate has dropped over time. Open to purchasing a new lock/gate hinges to be installed if that is the advice given. - Due date: Flexible

It’s a small picket fence gate approximately 1square metre in size which is slanting and needs to be aligned to rest of fence. Palings need to be removed and then aligned - Due date: Flexible

The treated pine gate will need to be approx 1000mm wide by 2200mm high. It will sit between two brick walls approx 1.2 metres apart. The metal frame may be a kit from bunnings (supplied). The gate can be treated pine palings (possibly overlapped)but not necessarily. The lock will be a sliding bolt and padlock (supplied) Owner will do painting. - Due date: Flexible

Hinges have broken away from post need replacing - Due date: Needs to be done on Friday, 29 April 2022

Gate required for gate in boundary fence. Galvsnised Posts already installed. - Due date: Flexible