Find trusted local electricians in VIC

Need 1 power Point middle of garage roof I have 2 power points in top of front wall and back wall as well.

I need some electrical sockets to be installed

Light fittings installed x 4 wall sconces and to ceiling Outside lights checked, not working x 3 Reconnect socket in kitchen

Need to wire the tv electrically through wall to PowerPoint.

Powercor has advised the mains box to the house needs to be replaced. Licensed electrician required to inspect and replace faulty consumer mains entry point where electricity enters building from street supply. Located on first floor exterior. Please quote including inspection and compliance certification.

Setting up a little wood working workshop in my garage and need a couple of power points. Photos show where I want them installed. Power switch board is right behind the wall. Need following: 3-off power points 16A each. All on one fuse 1-off power switch (16A 2pole) for future possibilitiesineed of something needing to be hard wired. Separate fuse required. Need electrical work certificate

Need a few electric switches replaced, since it’s broken or cracked.

One in pantry near existing Switch board . One under the island bench you can take from the Dish washer connection

Safety switch turned on, lights in the house work fine all plugs stopped working , trying to identify which plug is faulty and fix it.

Require floor lamp cord to be fixed.

I currently have a standard light which stops my screendoor from opening. I would like this to be changed to a downlight.

Remove and replace 6 downlights, I can purchase the necessary lights from Bunnings based on your advice

I need to relocate a socket up to 2 metres along a side wall - see photo. Before Friday 8 May please.

The working old down lights adaptor to change to plug system

Power outlet needs to be refined to wall. See picture. Also fan/light currently operates on one switch, needs to be split out to two to operate independently.

Needing a licensed electrician to install a power point and TV point on this wall so we can hang TV. Also needing the TV to be placed on the wall but can arrange to have this done separately if necessary.

Remove bedroom fan/light. Disconnect dishwasher, disconnect outside cameras

Looking for a practical handyman to install a lightweight side gate between two units in Hughesdale. The setup: -Gate and frame are already purchased and on site - One side has an existing panel/post to attach to - The other side needs a support — looking at a no-dig/concrete-free post from Bunnings (e.g. ground spike anchor) Measurements: Total fence to path width: 133cm Gate width: 78cm Side panel: 31cm Path width: 84cm Gate height: 120cm Back panel height: 124.5cm Front panel height: 124.5cm (approx.) What we need: Someone to assess, source a suitable ground spike or stake from Bunnings (nearby), and install the gate so it opens and closes securely. No concreting, no panels, no major earthworks. Goal: Keep a dog contained. Function over form — doesn’t need to look perfect. Budget is $200 all-inclusive (your time + any hardware). Happy to discuss if you have a smart, cost-effective approach. This is a job for a confident handyman, not a fencing contractor. If you’ve hung a gate before, this is right up your alley.

Hi, I’m looking for someone to install some lights in my bedroom. It comes with a remote so i would need that to work and to be connected to the switch as well. You will need to come with your own tools since I don’t have any. The last photo is the current light I have.

I have this bunker light I want to swap with a new one See pic of current light and pic of the new light Should be a quick and easy job but I just don’t want to mess with wiring myself