Find trusted local electricians in Balwyn North

I need a gas heater expert who can help me repair my gas heater from water leaking into it -need you to fix the water leaking and get the gas heater working properly

Add new circuit into switchboard to power a new bidet to toilet. Electrical Plug already fitted, plumbing already completed. Just need to install bidet and new circuit into switchboard so it doesn’t over power

Hi , I am needing a qualified electrician to relocate a power point and ethernet connection either horizontally or vertically (down) as I will be putting in a Samsung Frame Tv so require the area to be unobstructed. Preference would be to move both horizontally into the built in cabinet joinery (please see photo).

Replace 2x lights with 2x Phillip hue appear lights

I have demolished to the frame and need a licensed Electrician to make wires safe before the carpenter works on the frame. There are: 9 Power points 12 individual light switches Disconnect 5 obsolete wires (old phone foxtel etc) I will have to re install these PowerPoints and switches in next couple months once the new walls are completed. Also: Move 2 down lights about 50cm towards wall with insulation Thank you 🙏 Monica

Fuse box door, cut to size and install . 92cm x 62cm . Needs to fit well and snug so the bee's stop trying to move it!! It's cavity is probably not straight. .. Nothing in my house is straight ..

Electrical Re-wire - Power circuit 2 of them Full rewiring of power circuit to meet current electrical regulations Disconnect all wiring that is non-compliant or faulty. Re-wire all powerpoints that are non-compliant or faulty Replace all double GPOs with new double GPOs

Disconnect and remove existing power to allow for ceiling works. Supply and install downlights. 4x Supply and install a side flood light 1x Supply and install a front wall light 1x Supply and install outlets. 4x (general power and garage door power) Supply and install a power outlet for the outdoor water pump to connect from the rainwater tank (pump by others). 1x Supply and install light switches.

Perform Electrical Safety Checks on rental property in accordance to Residential Tenancies Act 1997 by Electricians and must be licensed with Energy Safe Victoria as Registered Electrical Contractors (RECs).

The hard wired smoke alarm keeps going off, I change the battery, and it still goes off. I would like to replace with a new one for certainty. Qualified electrician needed.

1 x light switch slightly sunken in (still works) - can be fixed so no longer sunken? AND 1 x broken power point switch needs replacing

Connect ikea vanity mirror - with light. The unit itself already installed but not powered. Need electrician to connect power. Room located on 1st floor . Unit is call storjorm.

To un install wall mounted Pioneer TV and disengage wiring going thru the wall.

Please see the photos. Please fix it asap.

Electrician who can replace an old Main Switchboard with a modern one in preparation for solar panel installation.

As per image, 2 down lights need installing

I’ve bought new down lights to replace the old ones (a total of 34 downlights). To fit the new ones, the ceiling holes need to be enlarged. Since these are plug-in down lights, no electrical work is required. We just need to unplug the old ones and plug in the new ones :-)

Need someone to install skylights for a new house in frame stage.

**Title**: Need an Electrician/Technician to Wire Ethernet Cable and Set Up WiFi Repeater **Description**: I need a qualified electrician or technician to run an Ethernet cable from a router on the ground floor to the 1st floor. The cable will need to be properly installed (possibly through walls or ceilings) and connected to a WiFi repeater to ensure a strong signal. The WiFi router need to be powered so need to install a power socket also **Requirements**: - Experience with Ethernet cabling and WiFi repeater setup. - Tools and materials to complete the job (unless I provide them). - Neat and professional installation (e.g., hiding cables if possible).

Rabbit damaged wire and a new plug exchange required.