Find a reliable cooktop installation and repair service near you

Looking for a licensed electrician to uninstall an existing hardwired built-in oven and install a new built-in oven. New oven has a standard power plug but happy for that to be wired without using the plug. Must be licensed and qualified to carry out the electrical work in Victoria.

I need to have an old oven removed and a new one installed. I am on the third floor, with no lift.

Need an electrician in Laidley North QLD doing a job for my rental property by removing the old cooktop and replace with a new one from the Good guys. Photos attached please let me know your quote thanks.

I need a licensed gas fitter to install a new 60cm 4 burner gas cooktop (Esatto ECG604WS, natural gas, cutout 560 x 490mm, bought from Bunnings). It replaces an existing Electrolux 60cm induction cooktop. - Existing gas supply is capped off in the cabinet under the sink (from a previous gas cooktop). Photo attached. - Remove the induction cooktop and fit the gas cooktop into the existing benchtop cutout. - Connect gas, leak test and commission all burners. - The induction cooktop is hardwired, so it needs to be safely disconnected, and the gas cooktop's electronic ignition needs a 240V power point under the bench. Please confirm if you can do the electrical part or if an electrician is needed. - Provide a Victorian Certificate of Compliance on completion. The cooktop will be on site. Photos attached.

quote for a Gas cooktop installation in a granite bench top. I am still trying to purchase a gas cooktop to fit the existing cutout. Some cutting of the benchtop may be needed.

Cooktop has been installed but it requires a small cut out in the cabinets as it’s not sitting flush. The joins of the cupboards below need to be trimmed/cut with a multi tool or something so that the cooktop can sit flush.

Old gas cooktop has been removed. New one is sitting in the hole, I just need someone to fit it off. It’s lpg metered gas

Repair electric oven, gas cooktop and rangehood — Dianella Looking for an experienced appliance repair technician to inspect and repair three issues: 1. Gas cooktop: One burner’s control knob has become very stiff and difficult to turn. 2. Electric oven: The oven has stopped working and appears to have no power. I suspect a wiring or connection issue, but the cause has not been diagnosed. 3. Rangehood above the cooktop: It takes a while to start after being switched on and makes excessive noise. Photos of the appliances and their brand/model labels are attached. Ideally, I’d like someone who can repair all three appliances. Please confirm your relevant WA electrical and gasfitting licences, experience and earliest availability. Please specify whether your offer includes call-out, diagnosis and labour. Any additional parts or repair costs must be quoted and agreed before proceeding. Timing is flexible, preferably as soon as possible.

We would like to replace the 60cm 4 burner gas cooktop, with the new one. Dispose the old one. Due to regulation need to be installed by licensed to install gas cooktop and an invoice

I am replacing my electric cooktop for a difrent model and need an electrician to reconnect it

## Licensed Gas Fitter Needed – Gas Cooktop Installation (Kogarah, NSW) I’m looking for a **licensed gas fitter with a valid NSW licence** to help install a new gas cooktop at my house in Kogarah. **Please do not apply if you do not hold the appropriate NSW gas-fitting licence.** **Preferred date:** Saturday, 17 October 2026, during the day after 12pm. **Parking:** Driveway parking available. ### Scope of Work 1. **Remove existing gas cooktop** – I can assist with removal and disposal. 2. **Install new gas cooktop** – Electrolux 60cm Natural Gas Ceramic Cooktop (Model: EHG635BE), already purchased. 3. **Enlarge existing benchtop cut-out** – The benchtop is laminate, and the existing cut-out needs to be enlarged slightly to accommodate the new cooktop. - New cut-out width: 560 mm - New cut-out depth: 490 mm I’m a qualified carpenter and can assist with the benchtop modification using a jigsaw and circular saw, if appropriate. 4. **Connect and safety-test the cooktop** – Complete the gas connection, installation and required safety testing. Existing gas and electrical outlets are available below the cooktop. ### About the Job I’m a qualified carpenter and happy to assist with suitable preparation and other tasks to help get the job done efficiently. **I don’t think the job will take too long**, especially as I can help with the removal and benchtop modification. All gas-fitting work must be completed by an appropriately licensed professional. Please get in touch if you hold the required NSW licence and are available on the preferred date. When responding, please confirm your licence, availability and quote for the job. Thank you!

We have an electric cooktop and oven that’s hard wired, we need an electrician to help remove the old wiring and install the new oven and cooktop

The spring in the bathroom sink plug is no longer releasing. I pushed it down, but it is now unable to pop back up. The cooktop ignition is also not turning on, although the gas is still working.

We have bought a secondhand oven and just need a hand to pull out and replace the old oven. Standard 60cm oven. Pretty flexible on times. No need to take away old oven, just to pull out and install the new (pictured)

Looking for an appropriately qualified/licensed appliance repairer or gas fitter to attend a short-term rental property in Windsor, Brisbane to diagnose and repair a gas cooktop ignition issue. Issue: - Gas is flowing to the burners normally - Burners are not electronically sparking/igniting - Guests can currently light the burners manually, but we need the ignition repaired - Make/model can be provided once confirmed We would like someone to attend as soon as possible this week, diagnose the fault and repair it where possible during the same attendance. Potential issue may relate to the ignition system, spark module, electrode or microswitch, however this will need to be professionally diagnosed. Please include in your offer: - Call-out/diagnostic fee - Your availability - Relevant licence/qualifications - Whether you can supply common replacement parts if required Please provide photos/details of the fault and completed repair for our property records.

Electrician required to install new cooktop and oven.

Oven replacement for rental property. The task involves purchase and installation. The current oven ( Simpson Evolution 906) is 60cm. I'd like a mid-range oven. Westinghouse WVE6314SD 60cm oven looks great and is approx. $600 See photos.

I’m looking for a qualified and licensed gas fitter/plumber to replace my existing gas cooktop. The job involves: * Safely disconnecting and removing the existing gas cooktop * Installing and connecting the new gas cooktop * Ensuring everything is safely and correctly fitted and compliant * Removing/disposal of the old cooktop I’m looking for someone who is properly qualified and licensed to carry out gas work. Please include your total estimated price for the job when making an offer, including removal of the old cooktop if possible.

I’m looking for a licensed electrician for a small job at my rental property in Clontarf next Wednesday, 7 October. There are two jobs to complete: - Remove the existing electric cooktop and install a new replacement cooktop - Replace a faulty/intermittent light switch I’ll purchase and supply the new cooktop and switch beforehand, so I’m really just looking for someone to handle the electrical installation and connection. I’ll be at the property at the same time doing a few minor maintenance jobs, so access is easy and there’s no need to coordinate separately with the tenant once the time is locked in. The cooktop is being replaced rather than repaired, so I’m not looking for fault-finding on the appliance itself — just removal of the old unit and installation of the new one. Ideally looking for someone who: - Is a properly licensed electrician - Can complete both jobs in the same visit - Is available Wednesday 7 October - Can provide the appropriate electrical safety/compliance documentation Clontarf QLD 4019. Please include your availability and labour price when responding. Happy to send photos/details of the existing cooktop and switch before the job if helpful.

Looking for a licensed electrician to install and connect a new oven at my home. The old oven has already been removed and disposed of, so only the new oven needs to be installed and connected. Please bring your own tools and let me know your quote and availability.