Find experienced local carpenters in North Brisbane

Custom timber floating shelf - 2590 long

Please see the attached photo: The white decorative wood batons (vertical and horizontal) on the front of the garage are rotting and falling off. We need a carpenter to cut and replace these.

I am a registered builder and am renovating a house and need a hand with a few last things to get it done a bit faster. Looking for a carpenter to help with the following: - install timber handrail and battened balustrades to new deck - install new external door to deck. Likely will need only a single day (8hrs). Please quote based on this. Thanks

Oil decking around pool x 2 coats

I’m working on a DIY project and my car isn’t big enough to fit the desk panel I want to buy. I would need someone to go to Bunnings, buy the desk panel for me, have it cut in store (or yourself, but the stores do it for free) and then deliver it to my house. It is the: Specrite 2400 x 900 x 33mm Timber Multi Use Pine Panel and I need it cut to 1700 x 800 x 33. The panel is $179. The budget for this job is for service/delivery. I’ll reimburse the cost of the wood.

We have a partially completed custom wardrobe joinery built into our wardrobe. I need someone to help finish it off with the melamine edging to cover the raw edges, and installing a clothes hanging rail

I need a clean, minimal 3-step stair block for a photo studio. Each step should be wide enough for 2 children to sit side by side, and finished in matte white (or prepped for me to paint). Must be solid

Carpenter needed to do some jobs

Three doors need adjusting: Firstly, Cupboard door needs reattached and aligned. Secondly, Bedroom door hits at the top, adjust so it closes again. Third, Laundry downstairs/outside door does not close. Adjust frame or door (or adjust door size a little-patch paint) so that it closes and locks.

I need the back replaced! I haven’t got the materials yet! So I’m Happy to pay for those once you have picked them up! Need done Thursday afternoon, or Friday!

Hi there, Could anybody build me a cabinet with a floating shelf and doors? Measurements: W 600mm H 1220mm D 680mm To be clear, I don’t have a flat pack that needs building, I require the whole cupboard/cabinet. Many thanks!

Build built in bench seat with draws/storage underneath in space in pictures. Lots of wires to be covered/tidied up also. Open to suggestions and negotiation of price.

I’m looking cabinet makers and carpenters.

I am needing someone who can cut and install a timber screen as shown to under my house. I only need this small area. It is 2.1m wide x 1.1 high and the end which is 0.4 wide.

Looking for someone who can cut and Install Filler piece above oven

In need of a cabinet maker to partially disassemble lower kitchen cabinetry (not island) so we can access behind. These cabinets will be reused so they need to be taken out carefully. Images attached.

Have two sets of outdoor timber treads (10 treads in total) which look a little worn. I would like to freshen them up by giving them a sand and staining them.

Cut out part of the existing pantry cabinet to fit a standard dishwasher 60cm wide. Clean up the edges where it is cut so it looks neat and finished. Leave enough space in the back for the plumber. If there’s extra space left over, we can either close it off with a panel.

I had dismantled a timber hard rail in my yard to install a concrete retaining wall. I have the timber fence post fixtures installed in the concrete sleepers so installing timber will be easier and more robust. It’s a Hampton style handrail. The timber handrail needs to be installed I got the timber. Additional timber can be purchased. Total length22m Need to install handrail and paint it white The concrete sleepers at 2.4m wide typically. So to be safe you would need to measure it out again. Best way to look at this project is to set out what material is needed for the handrail. Use much of the existing and then just buy new material from Bunnings as needed. That keeps the project nice and simple.

I need this entertainment cabinet which is built into the kitchen cabinetry removed. It is attached to the floor, the pantry and the wall. The space does not have to be restored (this will be fixed at a later date) but I need minimal damage. There is one existing pane at the bottom which is shared with the panty, this piece can remain in tact (will fix later) No need for disposal there are bins onsite. Open to negotiating price.