Find a professional local car service in Melbourne

2008 Mazda 3 Maxx Sport BK Series 2 hatch (build 04/2008), 2.0L petrol, manual, halogen (no HID). VIN supplied to accepted tasker for parts ordering and paint code. CORE JOB - driver's side (RH) front headlight: - Supply new aftermarket ADR-compliant RH headlight assembly with new globe sockets. Must be BK Series 2 HATCH part (04/2006-04/2009). Sedan and Series 1 lights do not fit. - Old socket/clip was damaged by arcing (globe pops out, a previous repair failed). Inspect loom-side H7 connector for heat damage, fit new pigtail if compromised. - Voltage-drop test on the headlight circuit. - New correct-wattage globes: H7 low, HB3 high, parkers/indicators. - Sign-off: run lights 10-15 min, connector stays cool, globe firmly retained, beam aim checked. OPTIONAL EXTRAS - quote each separately, same visit: A. RH rear outer tail light, NEW aftermarket only (current unit heat-damaged and crumbling). Correct-wattage globes, inspect bulb holder and connector for cause of overheating. B. Outer window belt rubber seals, all 4 doors (e.g. Machter WDS-MA001 kit or equivalent). C. Coolant expansion tank (pressurised type, 145 kPa cap). Dried coolant residue around current tank. Confirm leak source (tank/cap/hose) after fitting. D. Rough repair of rear bumper corner scuff (cracked/flaking paint). Sand back, prime, colour-matched aerosol blend (code from VIN). Tidy is fine, showroom not required. E. 7in double-DIN Apple CarPlay head unit (brand-name) replacing the factory stereo, incl facia kit, wiring harness, antenna adapter and steering wheel control interface (wheel buttons must keep working). CarPlay tested with my iPhone. Note wired vs wireless in your quote. LOCATION: Docklands 3008. On-site open parking and street options, or I can drive to your workshop (easier for the paint work). No deadline, flexible timing. Please itemise your offer (core + each extra) with part sources and warranty on parts and workmanship.

There is a fair bit of scratch happened while parking my new Mazda cx-5 car. The scratch is on the right back passenger door near the handle. The red color came out a bit no dent nothing. Can anyone please help with the quote to fix this?. Thanks

My tints getting old in the rear window and showing bubbles, need help reapplying new tint.

Replace right headlight globe. I have purchased both types of globes that could be recquired, although only one is needed. 2008 SUBARU FORESTER Replacement via opening the hood.

Need to have the heater core in my 2013 Ford focus replaced. Can bring to a garage or can be done at my house.

I’m seeking a mechanic to do a full checkup / service on my early 2000’s Toyota Echo. Can drive to a more convenient spot if need be. Within 10km of Brunswick West, VIC. - Due date: Flexible

I have a dashcam system (DDPAI 4K Dash Cam Z60 Pro HDR Front and Rear Interior) and a DDPAI Z60 OBDII Hardwire Kit - DC003, that I would like installed to work with the CarPlay setup I have in my Subaru Forester Hoping to use the dashcam as a reverse camera, but please advise if I need a separate camera for my reverse parking use, and then I will purchase that as well so that all three cameras can be installed at once. Thanks! John

I want a pre-purchase car inspection on a 2008 Subaru Forester X S3 Auto AWD MY09. The car is located in Prahran. I specifically want the undercarriage checked and a visual inspection of the engine bay. Also the head gasket was replaced at 180,000km, I just want a general health check. Looking for a shorter check for less expensive.

2 side panels have been dented and scraped. Looking for someone to bring them back to life. Have been quoted ridiculous prices. Maybe just fill with bog or something.

My drivers side door handle has been snapped off so I’m unable to open the door from the inside. So I need someone to replace the door handle if possible. I’m able to drive to any suburb to make it easier for someone to do the task.

I will buy an alternator to my Toyota Yaris 2006 and I need someone to install it. Should be a quick job for someone with the tools and knowledge

I need a new front grille and fog light grilles installed on my 2013 Audi S5 b8.5. A video of the grille install below. Bumper needs to come off to do this job. https://www.youtube.com/watch?v=m2zmWZXvZNw

Install portable wireless CarPlay screen (APHQUA A95) into BMW X3 E8 , hide wiring, connect audio via radio/cd input. I have already bought the unit and want as good an install as possible. Also run rear camera to the unit. I would like it to be powered by the cars ignition too.

Just regas of a 2014 Holden Commodore. Flexible with times, preferably over the next 5 days. Onsite or st kilda area

The dash cam is already installed and I need to fix the fuse wire as it is loosen now. Can any one help?

Looking for an experienced installer to hardwire and install a Thinkware U3000 front and rear 4K dashcam with radar into my 2018 Audi Q7 Hybrid. Scope • Hardwired install with parking mode enabled • Concealed wiring (no visible cables) • Rear camera install and alignment • Radar module setup • Full testing before handover Hybrid and European vehicle experience preferred. Please include your experience with Audi or hybrid installs and availability.

I need someone who knows e46 m3 gearboxes and can drop my SMG gearbox and reinstall a second hand option.

Need an oil and oil filter change. I can supply oil and filter.

Engine light has come on and I need someone to come out and check it and hopefully diagnose and fix the issue. I am away for work an hour from home and cannot afford to break down. The car has been having issues for a while now but lately has been struggling with the heat and could hear the engine lagging to go. Now the light is on. Located tarneit and need someone asap.

The car is shaking when I try to accelerate and needs spark plug and ignition coil (quantity unknown) replacement.