Find an experienced builder in Hughesdale

Assembly of this shed. Floor already prepared. https://easyshed.com.au/products/2-25m-x-4-5m-workshop-shed

We are planning to renovate our bathroom and need help with the demolition of the existing bathroom. Bathroom size: 2.6 m x 2.7m x 2.4m height (approx). The existing bathroom includes a bath tub, vanity, and toilet (see attached photo). The bathroom is located on the second floor. The job includes: • Demolishing and removing all existing bathroom fixtures and fittings (including tiles) • Moving all demolished material into the skip bin in the driveway Skip bin will be provided. Demolition in October

Need to replace the 7 year old pergola roof with a new one. It is located on the back of the house.

Want a licensed builder to knock down a 1800mm internal wall between kitchen and living area. This is a load bearing wall on a ground floor double brick apartment with one apartment above it. - Engineer drawings and calculations available - Body Corp approved - building permit in progress Scope of work: - Carefully remove approx. 1.8m section of a load-bearing wall as per engineering specs - Install structural support - weld additional steel plates with holes to the bottom of steel beam (for a pendant light) - Coordinate with me and other trades necessary - Ensure site is safe, clean, and protected during and after works (includes clean up) Also looking for carpentry for archway and plastering if available afterwards. If you want to inspect first please bid as low as possible. Open to all offers :)

Concrete for the drive way 8 meter by 50cm

Assembly and anchoring of an Easyshed onto an existing concrete block

We need a licensed electrician to wire and install LED lights on our pergola. The lights are already in place—just need proper wiring and connection to a power source. Please ensure all work meets safety standards.

We need an experienced professional to assist with three installation tasks. First, we require wall panel installation on a 2.7m wide wall using panels that are 3m long. Second, we need decking installed for a concrete area measuring 3.8m by 3.3m. The decking floorboards, which are 3m long, need to be elevated to match the height of the existing flooring. Lastly, we need an aluminum pergola to be assembled and installed. It comes with installation guide. Some materials for the tasks have been purchased, any additional materials required to complete the tasks will be reimbursed. You will need to bring your own tools. Experience in similar projects and a clean, professional finish are essential.

Need a draftsman to draft plans to obtain a building permit for a verandah. Need this done immediately as we are on a tight timeframe. Happy for you to come and see the property and then quote for job or quote for whole job up front. Please let me know in your offer when you can come out, and how long it will take to have plans drafted. I need all required documentation to submit to a building surveyor. Verandah will be roughly 4 x 9 metres.

Need the drain cleaned of leaves and drain cover fitted. I have the drain cover from Bunnings which will need to be cut to size and fitted.

I bought a shed from the brand EASY SHED, I need someone to assemble it. All panels assembled except, need to put them together. Size is 1.5*3m

Install Pergola with polycarbonate roof and guttering - Due date: Flexible

Require an existing sand pit to have a new sand pit cover and cladded to match in with existing deck - Due date: Flexible

Hi there. We need our driveway, porch and side timber fence painted. I assume the concrete will need to be pressure washed first - please include this in your quote. All paint and supplies to be supplied by you. Photo attached Concrete is In good condition, no repairs needed.