Book a professional blind repair service in Point Cook

The chain of a roller blind is broken. Need help replace the roller chain.

Simple handyman stuff.. such as cleaning gutters above garage of some plants and mud, fixing my motorised alfresco blinds which are not closing fully (the limits may need to be reset I think)

Need to fix blinds the chain came off from the ring

I am looking for an experienced blinds/roller blind installer to shorten the beaded chain/cord on roller blinds so that the operating cord/chain is positioned at a compliant height at least 1.6 metres above floor level, in accordance with Victorian rental safety requirements. Work required Shorten the existing beaded chain/cord on the roller blinds. There are 7 roller blinds which need this done Ensure the remaining operating chain is securely fitted and functions normally. And the fastener clips are installed properly Ensure the cord/chain is positioned so that it complies with the applicable Victorian rental safety requirements. Please check the completed installation and make sure there are no loose or accessible sections of cord that could create a safety hazard.

I have a blind of the size 2100 m - need to cut it to about 1900m width - exact dimensions will be provided

Install 3 roller blinds and tracks Install 1 set panel blinds

Install x2 2400mm new in box roller blinds in Point Cook

I have this pvc transparent fold blinds needs to be repaired. It is remote controlled and Motor works but it does not roll it up.

Install 1 small 120 cm Outdoor Blind (Already Purchased) + Guide Hoops in Alfresco. Left side (pillar): The blind will be drilled and fixed onto the front/outer face of the alfresco pillar — the face that is visible when standing in front of it. The blind will slightly cover the front of the pillar when viewed straight on. This is a solid pillar so direct drilling is fine. Right side (wall): There is a wall on the right that runs perpendicular to the blind’s direction. An L-shaped bracket (may be needed) to be installed on this right wall to create a mounting point in the correct direction for the blind end to fix onto. Additional fittings: I also need 2 guide hoops installed — one at ground level and one at mid-level — to keep the blind held in position and prevent it from billowing or sagging. Please note: • Blind is already purchased and on-site • Masonry/brick drilling required • Tasker should be comfortable sourcing or fabricating a suitable L-bracket. Or guide me to purchase the right one before the installation date. • Please ask for photos before quoting — happy to send them

Roughly 3 m wide. See picture

Need a black blind for this kitchen window from outside. Size 182cm X 70 cm

Fix outside blinds because they keep bunching up

Need broken window blind fixed

The chain of a roller blind broke when pulling and I have purchased new chain from Bunnings.

Need to repair the treading of the blind

Need to fix the side little roller with chain i will attach the photo you can look into it.

Need to fix the blind the turning wheel is broken need to replace or fix that. Rest everything all good i can send you the picture as well Please give me the quote

I have a new house, I need to get blinds installed in all the windows

The blind holder got broken and also the wall plaster got damaged. Need to fix the wall plaster and then put the blinds (rolling) back.

I have an outdoor shade I’m needing someone to install for me. I have everything for it including instructions, just don’t have a drill.