Find a professional awning contractor in Brisbane Southside

Modify the chain of aluminium awning window to restrict opening to 125mm x 3 windows total - professional glazier only

I have an awning from Bunnings to put over my outside side door.

Need someone to fit my awning onto my roofrack, that can come to my location

My roof racks and awning are currently off my Isuzu Dmax and I need them re installed

2 aluminium awning windows with winder handles and scissor-arm stays aren’t closing properly — they wind in only partially before stopping. Need someone experienced with window winder mechanisms to assess and repair (may need arm, gearbox, or full winder unit replacement depending on wear). Apartment access, easy to get to.

Install 1mx1.5m 4kg polycarbonate awning/canopy outdoor above solar inverter/battery on cement board and apply sealant The awning/canopy has been assembled, just mounting Will need ladder I can help lift the awning Must use the right screws for the cement board and drill into studs to ensure it will never fall Seal the gap with the right sealant

Need a handyman to install a 1.5m (wide) X 1m (deep) awning/canopy (already purchased) above the solar inverter/battery on a cement board outside. Prefer to be done between 7am and 8am.

Hi, I’ve just bought a Kings Plus 170° awning and I need someone experienced who can install it properly and safely onto the roof bars of my Pajero Sport. A few photos to give you an idea.

We need a window awning removed from the second story of our home. Needs a long ladder as it's quite high up, with the driveway (hard concrete) underneath. The awning is one of those old retractable ones but the mechanism has broken so it cannot be moved/retracted from inside the house. The awning frame is metal so has a little weight to it. The holes will need to be filled/patched once removed.

Install the attached curved awning/canopy above my outdoor solar battery . The awning is already purchased — just needs mounting. Details: Battery is installed outdoors on the brick wall Awning dimensions: approx. 155 cm (W) × 81 cm (D) Wall is accessible with clear working space

Hello, I'm hoping that someone can help me with some odd jobs around the house. The nails on the hinge of a door has come off, and I'm hoping that someone can fix it. I also have a Stratco Sunscape outdoor awning, and would like it installed in the outdoor patio area. Please find the instructions in the photos. Thank you, Anna

The awning control is broken inside and it cannot be retracted

Hi there, I am looking to replace my current front door due to water damage and would like to install a new awning as well. Could you please provide a quote for the following

We were involved in a car accident last week and my car has been written off by insurance company ~ I still have a DUNE side awning, dash cam, car stereo, and leather seats that I would like to remove from the vehicle before it goes to wrecking ~ can anyone help me with this tomorrow morning? Car will also be moved for easier access for removal of items.

Roofing/flashing repairer required to inspect and repair water ingress issues in 3 areas of a house/carport. To address the source of water ingress, reseal/waterproof the affected junctions, and replace any locally damaged fascia/trim where required. Large-scale replacement works are not expected unless clearly necessary. Part A – Carport corner/pillar Water appears to be entering the corner above the brick pillar, causing the black fascia/trim board to rot, with staining/runoff down the pillar. Required: Inspect and identify likely entry point Carry out targeted resealing/waterproofing of the junction/flashing Remove and replace the damaged section of fascia/trim if needed Make the corner watertight Part B – Front awning/patio roof Leak where the metal awning roof meets the house wall. Required: Inspect roof-to-wall junction Reseal flashing/joints as needed to stop water ingress Part C – Rear awning/patio roof Similar issue to Part B, but along a longer section. Required: Inspect leak points Carry out targeted resealing of flashing/joints as needed Ensure water is draining away correctly Photos attached. Please quote for the repair work needed to make the affected areas watertight. If any larger replacement works are considered necessary, please explain why and provide that separately from the base repair scope.

Hi there, my second storey metal awning has been wrecked from the winds and half of it has come off (see photos) I'd like some one to remove it and take the scrap away. It's fairly high up, around~7m and hoping it is not too much of an issue. Also the aluminnium panels are fairly long and would need to cut/folded before scraping. Budget is very flexible as my insurance provider needs me to remove asap. Thank you!

I bought the plastic awning from Bunnings which needs to be installed outside of the mantionry wall. I don’t have the drill bit as the hole needs to be drilled to 95mm deep with 10mm diameter drill

Need the awning dismantled leave material on site it doesn’t have to be removed and can be damaged don’t need to be careful

I have a job on today where I need an offsider to hold one end of a roller shutter awning. We will be on ladders with planks going across. You don’t need to be able to use tools or anything, just be able to hold one end of the roller shutter whilst I fix it in place, There are 2 awnings to fit.