Find a reliable appliance technician in Inner West Sydney

Need to change refrigerator chord and remove a broken plug pin from socket

Front load washer dryer DE2 error. Possible sensor reset or parts needed

Looking for someone to repair a Bosch Serie 6 front load washing machine (model WAT28620AU). Issue: • Machine is not draining properly during the cycle • As a result, it won’t spin and the door stays locked • I can manually drain the water through the filter, and once drained the door opens normally • No obvious blockage in the filter or rubber seal Based on troubleshooting, it appears the drain pump is likely faulty or failing intermittently. Scope of work: • Inspect and confirm issue • Replace drain pump (I can supply the part if needed, or happy for you to bring it) • Test machine to ensure it drains and spins correctly Location: Rhodes Flexible with timing. Let me know your quote and availability.

Replace oven light bulb Westinghouse oven

My dishwasher is showing up an error. Want this to be fixed immediately. This is a drainage issue and shouldn’t take more than half an hour to be fixed.

Brigges & Stratton P2200 not used for 6mths need service as going around Aus .

Our LG fridge keeps beeping as if door is not closed, when the fridge has been firmly shut, I think the fridge door is out of alignment somehow ?

Bosch Dishwasher - Type SD6P6B. Model number - smu68m15au/87 Our Bosch Dishwasher (came with the apartment) always leaves a funny smell whenver we open the dishwasher and whenever the dishes are cleaned. The smell sticks to the dishes and is unpleasant. We are hoping to have help fixing the dishwasher so that this smell goes away.

Gas stove not flashing all four not working, brand is Miele

I am having new bench tops installed and need a plumber to disconnect and reconnect my stove

Need to remove existing rangehood and install new one in its place. Both the existing and new ones are non-ducted 60cm slide out recirculating rangehoods. The dimensions of new rangehood exactly fit existing hood space.

I just got washing machine and the water is not drowning

Hoping someone can level my washing machine. It has feet though they seem old. I have bought new feet and would also like it to sit on these antivibration pads

Bosch dishwasher I think is a SMS63L08AU but the sticker has come off the inn we lip - have posted pictures . I think it’s the pump as I have checked everyone and the impella is spinning but the unit switches off after a couple of clicks when it starts up . Photos of the dishwasher attached . We think it’s around 10years old

Hi. I need an Omega 60cm Brushed Stainless Steel Slide-out Rangehood (model number ORT6WXA) fitting. Old rangehood removed. New rangehood purchased. 240v power supply available. Needs 6x 4mm holes drilling in the right place and the rangehood securing. Unable to do myself as recovering from surgery and cannot hold rangehood in place whilst drilling holes and setting up so it slides open etc. Am flexible on timing but would like the work done in the next few days if possible.

Fridge is leaking water looks like condensation from the back

My washing machine shook so much I need to shift it back and stabilise it so it doesn’t do it again. It is enclosed on 3 sides so very difficult to move. It probably needs a trolley and lots of strength.

I got a new microwave and the metal edging now doesn't fit around the new microwave so I think it would be best just to take it out and put in a cupboard without a door for any size microwave to fit it

Plumb washing machine to kitchen sink. Some hole cutting on the cupboards may be required to run the pipework. Bring required parts/hoses/connectors

Replaced an integrated dish washer with a new free standing dishwasher so now I need the old skirting boards cut under the dishwasher & the rest placed properly it’s approximately 60cm that need to be cut off & the rest to be replaced is approximately another 60cm