Find a reliable appliance technician in Hillbank

I had an electrician here a few months back and since he was here it stopped working, maybe a coincidence I dont know. My oven has lost power. I reset the electric box switches and main power, tried manual override and there does not seem to be an isolation switch for the oven. I believe it is hard wired. I also need the ignition fixed for the Cooktop. (Gas works fine just doesn't ignite)

I have an existing outdoor natural-gas connection at my home in Adelaide that was previously used for a BBQ. The current setup has an older flexible braided hose/regulator assembly terminating in a threaded female connection (photos attached). I would like a licensed gas fitter to: * Inspect the existing natural-gas BBQ connection and check for leaks. * Remove/replace the old hose/regulator arrangement as appropriate. * Install an approved natural-gas bayonet outlet/socket suitable for connecting an Australian Weber Q2200 Natural Gas BBQ. * Pressure/leak test the completed installation and ensure it complies with applicable Australian gas-installation requirements. Please quote including parts and labour. Licensed gas fitters only.

My dishwasher is flashing E1 and not draining properly, it is only 3 years old and prior to the error you could hear banging noises in the dishwasher when on an active cycle. I have tried pulling all parts out and cleaning filter etc, however does not seem to be working. Brand: Inalalto

Brought a new over that is smaller than the original on so have a big gap , turn the cup into a alcove or cupboard also needing to add height to stop top and fill in the gaps

I need the stove installed by an accrediated electrician.Remove the existing one.

I need a qualified installer to remove my old ceiling exhaust fan and install a new rangehood above my cooktop. The job includes: Installing the new rangehood (600mm) Running proper 150mm ducting up into the ceiling and out through the eaves/soffit (NOT the roof cavity) Cutting the eave panel and fitting a 150mm external vent cover Ensuring all ducting is sealed, supported, and compliant Removing or disconnecting the old recirculating ceiling fan Cleaning up after the job Notes: The eave location for the vent is already identified (I can show you the exact spot). Easy ladder access on the side walkway. Single-storey home. I will provide the rangehood — you provide ducting, vent cover, and any materials needed. You must have: Experience installing rangehoods Ability to run ducting through eaves Proper tools for roof/ceiling access Licenced preferred Location: Hillbank SA Preferred date: As soon as possible Please send photos of similar work you have done or confirm your experience with rangehood ducting. Thanks

Need an ev charger like the one shown on this website to be installed in our carport. https://www.evswitchstore.com.au/ Carport is on the other side of the house to the meter box. Standard brick veneer, tiled roof, single phase. Cheers.

The lock on my 10k washing machine has broken due to me having to force it open. Currenty just holding the door with tape

A cooler fan is broke down at the top of house. Not sure wha the problem is If you could please quote me on a fix would be great - Due date: Flexible

My washing machine (cold) tap connector has plumbing tape on it. The hose doesn't connect tightly enough and it leaks. - Due date: Needs to be done on Saturday, 10 June 2023

Hi I mistakenly loosen up the garage door spring tension while installing the motor. I need someone with pipe wrench to tighten up the spring and install weight as well as the motor and make door running smoothly. Thanks - Due date: Flexible

Needing someone to finish off my pizza oven - Due date: Flexible