Find a reliable appliance technician in Haberfield

I need someone to take out my old winch and replace it with my new winch. Model being Kings Domin8r Xtreme 12,000lb MkII Winch. You will need to take my bullbar, brush bars off

Bosch washing machine 9 years old. - does not drain properly - makes a double bip at the end of the cycle - cycles now take much longer than meant to - when it doesn't drain it stinks of water logging a few days after

We are removing our old 900mm stove / oven and replacing with another one same size

I need repairs on a Breville the Quick Touch Crisp microwave (has power but doesn’t start) A Breville oracle dual boiler coffee machine (water coming out of the water spout while brewing coffee) and a Breville super q blender (not turning on)

Install a gas fireplace plus flue

Install a new Bosch 60cm underbench dishwasher: https://www.bosch-home.com.au/en/mkt-product/dishwashing/underbench-dishwashers/underbench-dishwasher-60-cm/SMU4HVS01A

Hi, The heater of the pool hasn't been working around 3 months now and finally getting around to fix it. It works for a bit and then that fault high limit error comes on. I can reset the error code and turn it back on but the error will come back again within a minute and shut off again. I can keep turning it on but will max out at low 30 degrees with that method. I have the model number and the model code in the photos as well as photos of the filter system. Let me know if more photos are needed Flexible on time but the sooner the better

Figure out why dishwasher is blocked. And fix.

Lawn mower repair. The mower is a Victa 18" super mulcher. It stopped mid cutting the lawn . I have added oil, and cleaned air filter. Interestingly if I leave it a few days the mower starts again (with a big puff if blue smoke) but runs very rough for 2 to 3 minutes before stopping. Sounds like a carburettor or fuel line issue?????

Convert plumbing in a shower room so there is a supply line and drain line for a dishwasher to be installed.

Looking for someone to connect the gas stove to the existing gas supply. CHEF 54CM FREESTANDING COOKER WITH CONVENTIONAL OVEN WHITE CFG503WCH

Replace seal on LG front load washing machine. We have the new seal we just need someone to remove the old one and install the new one

I've moved house on the weekend and my movers have put my dryer and washing machine side by side rather than stacking them using the stacker like in our last laundry unfortunately. I didn't notice until they left and I'm unable to lift the dryer to stack the machines myself. It is relatively simple to do - as long as you can physically put the dryer on top of the washer. Suggest a couple of people could quickly lift and stack them. I have someone coming on Wednesday morning around 7am to install something in the space currently occupied by one of the machines so need them stacked either tonight or tomorrow at the latest.

We have 2010 Honda Jazz - we wish to install a reversing sensor kit - with the buzzer and LED display

Washing machine needs good clean and service. New door seal and hose may be required. See pictures. It's 10 years old and a bit smelly. The waste hose is blocked with sand.

I have google nest cameras (3) - I just need the wall plates attached to walls so that I can put on cameras (magnetic) - will need to drill into brick wall and maybe other surfaces. Quick, easy job.

BOSCH MAXX SENSITIVE laundry dryer. Scrapping noise can be heard and stops after a few minutes of operation.

Assembly / install 13 line ground mound clothesline on concrete. Link https://www.milkcan.com.au/product/13-line-above-ground-mount-med-large-family/ Instructions https://www.milkcan.com.au/wp-content/uploads/2022/07/13-line-above-ground-clothesline-instructions.pdf

It’s a westinghouse freestyle fanforced oven, (gas) noticed it did not heat up when I went to use it; I think the rear heating element needs replacing, similar issue happened 4-5 years ago - Due date: Needs to be done on Thursday, 25 January 2024

Hi there My ryobi pressure washer has been used twice and stopped working. The motor runs fine but water pressure just drips out. I’ve cleaned the nozzle, inserted wire rod to clean the nozzle of debris but nothing is working. Need someone to fix please - Due date: Before Sunday, 21 January 2024