Find a reliable appliance technician in Greensborough

Fisher paykel can’t take the load

install dahua nvr cameras x4 second floor and ground floor, connect dmss

UNOX combi oven. Works well just doesn't reach to high temperature. New seal installed. But temperature doesn't reach over 150 degrees Celsius. Need someone to come either 7:30am or after 5pm as kitchen is very small.

Dishwasher showing error code F84 - with inlet/drain light and rinse aid light flashing

Need a dishwasher installing. Apparently a connector is needed that i don't have.

Bosch dishwasher fills up with water when not in use

Pool pump not working..needs repair or replacement considering the cost Model number Hayward super sp274

Service of a natural gas patio heater

Replace my old rangehood with a new one - with a fixed 90 can of similar model.

It’s pretty loud and I suspect the bearing are an issue. The brand is Fasco

Westinghouse double oven PDL 790W, the top oven does not heat up. Lights go on, but no heat. I haven't checked the lower oven. Also, the top oven door doesn't open all they way, so that could be fixed as well.

Need to replace the existing cooktop and Iinstall new one. Also need to dispose old one

Hi all, I need help installing x6 security cameras around the outside of my house please. I bought the Swan cameras and my house is a two story home. Please see attached for what the house looks like and the cameras I have purchased. Thank you

Hi, Would like to add/install 2 cameras to existing CCTV. Also, 2 camera are black out. Not sure the reason.

Stove and oven “clicking” when power switch is turned on. Need someone to stop this from happening, unsure why it started in the first place out of no where. Unsure on industry standard, therefore pricing is negotiable.

the oven now will not stay lit. When trying to light the oven, I would turn on the gas and then pull the switch to ignore the flame. I would hold it for around ten to fifteen seconds and then let go which would keep the flame burning. Now (as of uesterday), when lighting the gals and pulling the level in the over to ignore the flame, it will ignite but the flame goes out as the gas stops as soon as it is let go. I have done research with the help of Andrea which Made a few suggestions. As I did not wish to try and take the oven apart to do anything, I did notice that it said that I could hold it longer and that would help the element heat up. I did this for nearly a minute and it stopped straight away as soon as I let the lever go. I also decided to leave it over night just incase it needed some time and today it is acting the same. We use the oven multiple times a week and it would be great if this could be looked into. I am hoping it is only something small. One investigation said that it could be a small metal item that is near the inner pilot that is not registering the the flame has heated up and thus turning the gas off for safety reasons.

Need to move the freeze and new washing machine from Greensborough to Watsonia. Important - Washing machine will also need to be installed.

Our premises need to get security alarm system to be installed by licensed person, thanks

I have two Croci EOS awnings in my backyard, one works fine, one has a ripped cloth that needs repair or replacement. I need help with the repair or replacement of the awnings cloth. Dimensions Width 3000mm Projection 5500mm.

Someone to come around and set up my home security system. Photos of the property below. 4 cameras. One front of house, one rear, one down the side and one other side.