Find a reliable appliance technician in Croydon NSW

Fridge is leaking water looks like condensation from the back

Agrade canopies, Rangehood Flue. Model No: AGF1200PRO. Task requires: AGF Rangehood installation with external roof Mout Motor Supply and Install Metal Flashing Apx 4 m to ensure no leaking through the gaps.

We bought a rice cooker overseas she mistakenly plugged it in without any step down transformer. The cooker short circuited our sockets and a bit of smoke came out. Before buying a step down transformer I want to figure out if it can be repaired

Our washing machine often doesn't start or can't open the door, it produces a clicking sound as if the door can't lock/unlock

Steam function in Espresso machine non functioning

The Steam/Hot water function of the machine not working. Tried de-scaling, factory reset all the usual options. The wand DOES work in the descaling mode though

Hi, I have two small plumbing / appliance issues at home: 1️⃣ Tap handle issue The tap handle turns right but won’t close, and only turns left to shut off. Possibly a reversed or worn-out cartridge. Need it repaired or replaced so the tap works normally. 2️⃣ Dishwasher issue (Omega ODW707XB) The dishwasher powers on and the display works, but no water enters during operation. Could be due to a blocked inlet valve, float switch issue, or water connection problem. Need someone to inspect and fix it so it fills and washes properly again.

Dryer pump needs to be replaced- not pumping out water

Error with the bean hopper - possibly a sensor but unable to use machine

Washer and dryer need to be connected to water supply and gas I’m assuming

The old wall oven (60cm) has been disconnected and removed, now need an electrician to install a new unit. No wiring to be changed, should be a simple job. The new unit is OMEGA 60cm oven model OBO606M.

Remove old rangehood and install new one

My fridge’s water filter needs replacing. That in itself would be easy if I had the part, but whoever installed it didn’t properly mount the bracket to the cupboard, so it needs repairing/reattaching. Filter model 847200 as seen in photo. I had a filter in stock too, but it was the wrong model.

Existing built under Bosch dishwasher (SRU53E15AU) has conked out. We’re looking to replace it with a full size (60cm wide) model (not yet purchased, but likely an LG QuadWash). The existing gap needs to be extended by 15cm to allow for installation. Large corner kitchen cabinet to be adjusted accordingly (see pictures below). Seeking for work + materials from qualified cabinetmaker.

Need someone to inspect and repair Bosch washing machine During the spin cycle washing machine become very shaky and loud.

The rubber band of my washing machine door seal is loosened so it's leaking while washing. It is Bosch series 4 7.5kg front loader. Budget excluding parts.

The washing machine sometimes doesn’t start, it seems like the door cannot lock

Disconnect current 900mm dual function oven and install similar new oven. Old oven to be disposed of. Will need cerificate of compliance

Looking for a licensed and experienced plumber to inspect and repair a minor leak (~0.024 litres per hour) at the water intake connection of a recently installed dishwasher. Scope of Work: Inspect a dual-outlet (T-type) water supply connector installed between the mains and sink/dishwasher. Assess leaks occurring at the main threaded connection and dishwasher inlet fitting. Verify proper use and application of PTFE (plumber’s) tape and ensure all threaded connections are correctly sealed and torqued. Check for damaged or misaligned gaskets or washers within the fittings. Investigate potential causes of water backflow from the dishwasher that may be contributing to the issue. Ensure there is no damage or restriction to the mains water supply at the point of connection. No new install or major rework is needed — just troubleshooting and correcting an isolated leak issue at the existing connection.

I need someone who is familiar with OKI MF printer. I have taken apart the drum, cartridge and tried to put it back but it is making unusual noise and error code 544.