Hire trusted experts for dishwasher repairs in Croydon NSW

Install of Bosch dishwasher, potentional service or repair… We have moved house, so we need the dishwasher to be reconnected and installed under bench. Prior to the move, it was making “strange noises” during the wash cycle, although it seems to be washing ok. I suspect it might need some sort of service - maybe replacing filters or checking for blockages etc. Not really sure. Model is SMU68M05AU/50 FD 9210 It’s probably 13 years old at this point. Not sure if parts like seals or filters are/should be replaced… or if they are available etc. Main thing we need is to get it re-installed, and then advice on what is serviceable or needs repair, and costing for those.

Hi, I have two small plumbing / appliance issues at home: 1️⃣ Tap handle issue The tap handle turns right but won’t close, and only turns left to shut off. Possibly a reversed or worn-out cartridge. Need it repaired or replaced so the tap works normally. 2️⃣ Dishwasher issue (Omega ODW707XB) The dishwasher powers on and the display works, but no water enters during operation. Could be due to a blocked inlet valve, float switch issue, or water connection problem. Need someone to inspect and fix it so it fills and washes properly again.

Existing built under Bosch dishwasher (SRU53E15AU) has conked out. We’re looking to replace it with a full size (60cm wide) model (not yet purchased, but likely an LG QuadWash). The existing gap needs to be extended by 15cm to allow for installation. Large corner kitchen cabinet to be adjusted accordingly (see pictures below). Seeking for work + materials from qualified cabinetmaker.

Looking for a licensed and experienced plumber to inspect and repair a minor leak (~0.024 litres per hour) at the water intake connection of a recently installed dishwasher. Scope of Work: Inspect a dual-outlet (T-type) water supply connector installed between the mains and sink/dishwasher. Assess leaks occurring at the main threaded connection and dishwasher inlet fitting. Verify proper use and application of PTFE (plumber’s) tape and ensure all threaded connections are correctly sealed and torqued. Check for damaged or misaligned gaskets or washers within the fittings. Investigate potential causes of water backflow from the dishwasher that may be contributing to the issue. Ensure there is no damage or restriction to the mains water supply at the point of connection. No new install or major rework is needed — just troubleshooting and correcting an isolated leak issue at the existing connection.

There is always water at the bottom after use. model: ASKO D3530

Dishwasher doesn't always drain properly and leaks. I've cleaned the filter and also checked that the drainage pipe is clear and have replaced the drainage clamps. Dishwasher brand is Platinum