Find trusted amplifier repair experts near you

I have a 2004 ba ford i would like my pioneer amp installed into the factory wiring ive already installed the sub so u can easily run the power and ground wires through 2x3way 4 gauge spliters i have,I have everything needed just the amp needs the installation ive swaped the speakers already thank you

Hi! Need someone with a feel for these things to connect the old to the new. 65 inch Samsung television to audio technica turntable to an old but good Yamaha amplifier with Klipsch speakers….

There is an amplifier that needs swapping it’s plug and play with the current amplifier There is also 4 walls speakers that need to be removed and swapped with the new units. The current brackets will need to be removed and the new speaker brackets will need to be fitted 3 out of the 4 speakers will be into brick and one into timber The speakers will also need the wiring connected. Again, this is a LFL system so not complicated You will need a big ladder as they are situated about 3.5m off the ground in a warehouse

My underseat Sub stopped working, was installed at autobahn.bougth another I fitted it but still no sound

I have a SV6 Ute 2010 with a kicker subwoofer and amplifier I believe there is an issue from the subwoofer to the amplifier wiring may need a new wire $70 if fixed

No signal comes on tv. Antenna amplifier on roof need to replace

I need someone to install my subwoofer and ampli on my honda jazz

onkyo tx nr929 av receiver burnt transistor repair

I currently have a projector and amplifier installed that I upgraded about 2.5 years ago. I’m wanting to swap them out with the two old units I have as I want to put the upgraded units somewhere else.

The Amplifier for my car stereo is not working. The PCB inside needs repair. I need preventative reflow of all power/relay/critical joints and component inspection. Task is described as "onsite" but I would presume the PCB would be taken offsite to be repaired.

Needing someone to quote for repairing this Focal Amplifier. The protect light is appearing. Happy to bring it to you or for you to come to me. Located at Browns Plains 4118.

I have an amplifier that requires a difficult to find power plug so want to install a more common round 2.5mm socket. Need the new socket soldered to the circuit board

Circuit board test and repair

Need 2 car amplifier's fixed

Need help diagnosing a problem with a custom 125kHz low-frequency receiver circuit for a university electronics project. The amplifier stage works perfectly (verified with oscilloscope - clean 18V output), but when I connect it to an audio transmitter module (TS832 FPV transmitter), the signal disappears despite using isolation resistors (2kΩ, tried 4kΩ). Components involved: AD8129 differential amplifier (±9V supply) TS832 5.8GHz FPV transmitter (for audio relay) Custom tuned 125kHz antenna Have oscilloscope and all test equipment available. Just need someone experienced with RF/audio circuits to help identify why the transmitter is loading down the amplifier output.

Experience person to put together a springless trampoline

Repair car audio tunex amplifier.

Hi everyone, I’m looking for a qualified technician or workshop that can help repair an amplifier that is over 20 years old. I’ve tried a few repair places already, but they’ve been unable to proceed due to difficulty sourcing parts. I do have a technician’s report detailing what needs to be repaired, which I’m happy to share. I’m open to specialists who work on vintage or older audio equipment, or anyone experienced in sourcing or substituting obsolete parts. Any leads, recommendations, or advice would be greatly appreciated. Thank you.

Syrup amplifier to new TV connection with surround sound and please set up PlayStation and anything else that needs to be hooked up

We have an audio system at one of our stores in Fortitude Valley that needs checking, looks like the amp may have blown, just need someone to check it out and confirm the problem