Hire a trusted stove installation and repair service in NSW

I have an existing 900 mm-high oven cavity and am considering installing an Electrolux EVEP6615DF 60 cm built-in pyrolytic oven. I need the existing cabinetry modified to accommodate the oven in accordance with the manufacturer's required cavity dimensions, including any required shelf/support, infill panel and ventilation clearances. Could you please provide a quote for the cabinet modification?

I have an AEG 4-burner gas stove. Three burners are working normally, but one burner has an issue. The affected burner lights up normally when I press and hold the knob, but the flame goes out as soon as I release the knob. I have tried holding the knob down for around 15–20 seconds, but it still does not stay lit. I believe it may be an issue with the thermocouple/flame safety device, but I need someone qualified to inspect and repair it. Looking for someone experienced with gas stove repairs who can diagnose and fix the issue safely.

The spark in Miele cooking stove is not working. We are using lighter and it’s fine.

The exhaust fan above my gas stove is not working, I suspect it is clogged as I have not had it cleaned since it was installed 10 years agove

Ignition switch not working for my gas stove

In alto stove need to convert to lpg

After small stovetop fire, the integrated range hood is irreparably damaged, needs replacement, some of the external cabinet doors need repaired and tiles needs a clean.

Hi, there are 2 out of 4 burners that currently not working as photos attached. Also the stove knob I think a bit hard to turn. We need professional to fix this

Stove top won’t ignite, can be manually lit and gas works.

Need someone to install 2x Philips GU10 LED bulbs (warm white, 4.6W) into the light fitting on my rangehood above the stove. I've tried a few times myself without success — might just need the right technique or the fitting could need a quick check. Should be a very quick job for someone handy.

I need a stovetop installed. It is the same model as the current one but I dropped something on the glass and broke it. I have the new stovetop so I just need an electrician to remove the old one and install the new one. It is an Esatto 60cm Ceramic Cooktop with Touch Controls

I have just replaced my gas stovetop with an induction one and need someone to help cap the unused gas line.

Please quote for: Removal of fan & fan switch Replace electric cooktop with another 60cm cooktop.

I need a certified electrician to replace electric cook top.

We got a new electric oven. We just need our old oven disconnected and reconnect the new oven. Photos are of the old oven. Located in Penshurst, NSW

Finally giving in - need to install plugin range hood within existing cutouts and reattach cupboard doors + remove old induction stove top and install nose one (hardwired) stripped screws up top of range hood through cupboard will need removing

Gas stove , my nephew installed it but I have fear it might leak or not installed properly!! Its a 15 min job so dont send quotes costing hundreds

Licensed electrician needed to disconnect a hardwired freestanding electric stove/oven and reconnect a new like-for-like replacement on the existing circuit. Straightforward swap, no new wiring needed. Summer Hill NSW 2130 Must be licensed with valid NSW electrical licence Certificate of Compliance (CCEW) required on completion Flexible on timing, weekday pls Please include your licence number in your offer. Thx

My stove is damaged, still works but i bought a replacement and need an Electrician to wire it up. Its like for like should be screw a couple of wires. Need it done today as its end of lease.

I need the gap between my stovetop and bench siliconed so that it does not collect crumbs/dust/grime. Silicone colour will need to match my bench top colour (ceasarstone colour “airy concrete”).