Hire reputable rangehood installation and ducting services in NSW

Bought a new rangehood and size doesn't fit by less than 50mm width

Installation of a pullout 60cm rangehood

Remove and install existing rangehood with one supplied by me. Exact same canopy type 900mm. Ducted outside and ducting already in place. disposal not required. Please send me a quote.

remove old rangehood and install new one

Supply and install a 60cm rangehood, including removal and disposal of the existing unit.

I need someone to install the canopy rangehood for new kitchen

Rangehood Installation 90cm

I need an old rangehood removed and a new one I've purchased to be installed. Licensed electricians only, proof of certification required. Weekend installation preferred. Stirling Rangehood pictured is the new unit required to be installed.

I need to install 90cm Undermount Rangehood (Model no SW-220CB) to my existing kitchen duct. Please see pics

Require rangehood replacement, existing hole and electrical in place. Will supply rangehood, not sure if ducting requires replacement, outside vent might. Experienced people only in this field or else ill just book through Good Guys recommended.

I need someone to install the canopy rangehood for new kitchen

Looking for someone with kitchen cabinet experience to help install a new 900mm x 300mm sliding rangehood. The new rangehood vent area is larger than the existing one, so the surrounding cabinetry will need careful adjustment to accommodate it. We need someone who can handle both the installation itself and make the necessary modifications to the existing cabinets, keeping everything looking neat and intact. The cupboard is 300 deep, the current air vent area is 200, but new one is 300 deep, so the lower shelf area needs to be adjusted out effectively. New Range hood is a Westinghouse Model Number: WRR904SB, dimensions attached in image.

Kitchen rangehood installation there is a cabinet that needs to be cut from the inside maybe some doors readjusted

Supply and install rangehood in kitchen.

Removal of old pull-out kitchen range-hood and installation of new one

Hi. I need an Omega 60cm Brushed Stainless Steel Slide-out Rangehood (model number ORT6WXA) fitting. Old rangehood removed. New rangehood purchased. 240v power supply available. Needs 6x 4mm holes drilling in the right place and the rangehood securing. Unable to do myself as recovering from surgery and cannot hold rangehood in place whilst drilling holes and setting up so it slides open etc. Am flexible on timing but would like the work done in the next few days if possible.

Remove old rangehood and install new one. Existing rangehood is a 90cm pullout Omega. New rangehood is a 90cm fixed Omega https://www.appliancecentral.com.au/orf90xl-omega-90-cm-stainless-steel-fixed-rangehood?language=en&currency=AUD&gad_source=1&gad_campaignid=11267016658&gclid=Cj0KCQiAprLLBhCMARIsAEDhdPe-OOj4ynlTxLLPbhMcawY6uVQIhYdzB2ua4L6w2I9vtTMfK2YIBDUaAiHCEALw_wcB

I have two newly built kitchens. I need the most budget recirculating rangehood supplied and installed. The cooktop will be two burner electric stovetop plug in. One is lower floor and other is second floor.

2x rangehood installs 3x power outlet replacement Will supply both rangehoods and the the power sockets. But you might need screws etc fittings/fixture for rangehood. Adjust / fill a loose door knob Note it’s two apartments but just 2minute drive from each other I can go with you both based next to central station.

Require a licenced electrician to remove and install like for like Smeg oven and rangehood