Find a reliable appliance technician in Outer West Sydney

Hi I would need help with replacement of 3 (out of 4) electric bed base massage motor. The bed base is in use. The parts are already delivered to our customer. As this is a service for our customer, hence there will be a strict set of requirements to follow. Our customer will not assist in any parts of the task. We will not deal outside of Airtasker. The replacement will be similar to this yt video https://www.youtube.com/watch?v=nj8Pfga6kbQ

We are having new kitchen bench tops installed at noon today and forgot to arrange to have an electrician disconnect the cooktop. Urgently need someone to attend at 11.45-12 to disconnect it.

Installation of washing machine - it’s at height - inlet pipes and drain pipes need to be connected - I have pipes

I set up my machine that still works fine according to my sister. When i turn it on it runs, but the water will not drain.

The cord of my GHD Platinum+ got melted and I need to have the cord repaired or replaced

Pilot button will not stay down/latched, so pilot light will not stay lit and main burner cannot be lit. No heat.

One of the gas burners not holding the fire after ignition.

Westinghouse dishwasher not draining. May need new drain pump

I think my washing machine may need the drain pump replaced. Everything seems to be working fine except when it comes to the water draining, nothing happens.

i need the correct elements purchased and fitted to ovens

Need a new kitchen tap bought and installed so we can use Bench top DW and the taps

I have an Amantii TRD-30 electric fireplace that is completely dead with no display or lights. I need someone who can diagnose internal power supply, fuse, thermal cut-off or control board faults and then fix it if its an easy fix. The heater was purchased as brand new faulty from a shop. Located in St Clair.

I need someone experienced with washing machine repairs to replace the door seal/gasket on my Hisense front loader (model HWFY7514). I've already purchased the correct replacement seal — it's the genuine HWFY7514 seal with the Pure Jet spray hole, so no need to source parts. The job: • Remove the old damaged door seal (mould-affected, needs replacing) • Fit the new seal, making sure the Pure Jet nozzle aligns correctly with the spray hole • Refit the retaining clamp/ring securely • Run a quick test cycle to confirm no leaks and the door seals properly Must have prior experience fitting door seals on front loader washing machines — please mention relevant experience in your offer. I'll have the machine accessible and unplugged, with the new seal and manual on hand. Should be a straightforward job for someone who's done this before — happy to discuss timing. Budget: $60–80 (labour only, part already supplied)

Part of the silicon has ripped which is causing some of the water in the washing machine to leak out when it’s running. We would like the silicon replaced or repaired if possible.

Both my GHD Platinum+ and GHD Max straighteners are flashing red and no longer heat up. The warranties have expired. Could you please advise whether these models are repairable and provide an estimate for diagnosis or repair?

Replace new dishwasher with old dishwasher. Located in Llandilo. Please only accept this task if your confident or have done this before

Ride on lawn mower not turning over need someone with auto electrician experience to diagnose issue. Thnks

Installing a dishwasher to an existing plumbing line location: Cnr Doonmore St & High Street date: 8/5/2026 time: 2PM

Hi, I need a handyman to come have a look at my washing machine. It could very well just be a loose tap. I'm not sure it's just been leaking when we do the wash so whether it is or not I just like to get it fixed properly. I don't think it'll take much of your time at all and my Cleaner will be there from 11 am until around one or 2 pm tomorrow so it must be within that timeframe please please do not post an offer. If you cannot come tomorrow after 11 am thank you