Find a reliable appliance technician in Blacktown

I possess a Bromic brand indoor gas heater that connects to the wall. The push start button, which controls the on and off function, becomes jammed when pressed to initiate the heater. Consequently, each attempt to start the heater is unsuccessful due to this jamming. Replacement of both buttons, as depicted in the attached photographs, is required.

Looking for an experienced plumber to: * Disconnect and remove my existing Fisher & Paykey double dishdrawer dishwasher (under bench) * Install a new Bosch series 6 dishwasher (under bench) in the same location * Ensure all water, drainage, and electrical connections are properly connected and tested * Check for leaks and confirm the dishwasher is operating correctly after installation * Take the old dishwasher away for disposal

Fisher & Paykel dishwasher of DW60 model heating element not working. Otherwise dishwasher is running and washing utensils but it is not effective as water is not heated.

Washing machine comes up with FA and it’s locked cant figure out how to fix it The brand is HAIER

Gas line inspection from Jemena found weep holes which need sealing up

License electrician only. Remove existing 90cm rangehood and install new 90cm rangehood. New Rangehood is silent rangehood with motor to be installed in the ceiling cavity Single story house, enough space is the attic

I have a Beko heat pump dryer model BDP710MG which has stopped heating. Either thermostat or heat element not functioning. Request quote for parts and labour, prefer no service call out fee. Please respond be email in first instance.

Hisense, HSAA16FS latch either nèeds repair or replacement Unable to start the dishwasher ,wont change modes ,door is not closing tightly

F03 code on hisense washing machine

My washing machine is playing up and now has stopped LG Inverter direct drive 14kg top loader I have add for approximately 5 years

Hi guys, Need someone to remove my old gas stovetop and install the new one that I have purchased. Thank you

Looking for someone to connect my gas pipe (already installed) to the cooktop. About 60CM between connection to Gastop (2).

Error message OE for LG top loading washing machine. Have tried all the suggestions in the trouble shoot guide. See in attached photos.

Disconnect the old oven Bosch HSG656XB6A (no plug) and install the new Bosch HBF134EB1A (10A plug). I will keep the old oven.

I think the seal on my dishwasher hose is leaking. I don't have the correct tool to get the seal off and the seal to replace it with. Sounds pretty easy for the right plumber. Photos are of top shelf under the sink and the shelf below with the hose and the water leaking down the hose. And I'm only guessing it's the dishwasher hose. Let me know if you need more photos. Please note this is in Blacktown not Shanes Park

Hi, looking for an experienced handyman for two small jobs in my kitchen — should be a quick visit. Job 1 — Kitchen range hood replacement Replacing an existing range hood with a new one of the same size. The new unit is plug-in (standard power point, no hard wiring). The job is simply: • Unscrew and remove the old hood • Mount and screw in the new hood (same footprint) - Devanti • Plug in and confirm it works Note: there is one screw at the back of the unit that is a little tricky to access — please come prepared with an appropriate screwdriver or extension. Photos show the 2 screws holding up. Job 2 — Under-sink tap screw tighten A new mixer tap has been installed under the sink and there is one screw head that needs tightening. Very minor — just needs the right tool and a steady hand. Both jobs are straightforward and should be quick. Please message if you have any questions.

Install freestanding oven and gas cooktop and must take away old one. *Location Marsden Park NSW 2765 Need to be licensed plumber and gas fitter

1. One of bath tub taps has come loose, need to repair/replace 2. Replace dishwasher pipe that releases dirty water 3. Help screw on pipe to a tap 4. Install bidets in 2 toilets

Hi, I need a 7kg clothes dryer wall mounted in the laundry, above the washing machine. The dryer will need to be securely installed on the wall with the correct brackets/fixings. Please bring the required tools and confirm if you can supply suitable brackets, or let me know what I need to purchase beforehand. Looking for someone experienced with dryer wall mounting and able to ensure it is safely secured.

The washing machine needs to be connected to the water outlet. Need tool to remove cap