Find a reliable appliance technician in Blacktown

I need a small chip on the kitchen bench top to be repaired. It’s just a fraction size of a 5 cent coin.

Simpson ezysensor washing machine belt broken and door seal broken

Dish wash error 1E .. stopping in the middle with the below error

I need a licensed gas fitter to confirm the reason why my gas meter is not registering usage. The meter shows the same reading since last couple of months. On approaching the gas distribution company they have advised to get this checked with a licensed plumber or a licensed gas fitter to confirm if the fault is in gas installation or in the gas meter. If the fault is in gas meter they will replace it but they need confirmation on this first

Electrolux Gas Cooktop burning with yellow flame - just one burner has this issue.

Our Samsung washing machine stops mid-cycle and trips the RCD. After draining the water and restarting, it resumes working but makes a loud clicking sound both before starting and after finishing the cycle.

One of the valves on my gas stove cooktop is stuck in down position. I need it fixed so i can turn gas on and off for that burner.

I just got a Bosch Series 2 dish washer and my plumber cancelled on me last minute. Could I get some help removing the old dishwasher and installing the new one. Happy to review your quote. I'm in Stanhope Gardens, 2768 NSW

3 phase shredder trips circuit breaker immediately it is turned on. perhaps wired wrong?

F03 code on hisense washing machine

My washing machine is playing up and now has stopped LG Inverter direct drive 14kg top loader I have add for approximately 5 years

Hi guys, Need someone to remove my old gas stovetop and install the new one that I have purchased. Thank you

Looking for someone to connect my gas pipe (already installed) to the cooktop. About 60CM between connection to Gastop (2).

Error message OE for LG top loading washing machine. Have tried all the suggestions in the trouble shoot guide. See in attached photos.

Disconnect the old oven Bosch HSG656XB6A (no plug) and install the new Bosch HBF134EB1A (10A plug). I will keep the old oven.

I think the seal on my dishwasher hose is leaking. I don't have the correct tool to get the seal off and the seal to replace it with. Sounds pretty easy for the right plumber. Photos are of top shelf under the sink and the shelf below with the hose and the water leaking down the hose. And I'm only guessing it's the dishwasher hose. Let me know if you need more photos. Please note this is in Blacktown not Shanes Park

Hi, looking for an experienced handyman for two small jobs in my kitchen — should be a quick visit. Job 1 — Kitchen range hood replacement Replacing an existing range hood with a new one of the same size. The new unit is plug-in (standard power point, no hard wiring). The job is simply: • Unscrew and remove the old hood • Mount and screw in the new hood (same footprint) - Devanti • Plug in and confirm it works Note: there is one screw at the back of the unit that is a little tricky to access — please come prepared with an appropriate screwdriver or extension. Photos show the 2 screws holding up. Job 2 — Under-sink tap screw tighten A new mixer tap has been installed under the sink and there is one screw head that needs tightening. Very minor — just needs the right tool and a steady hand. Both jobs are straightforward and should be quick. Please message if you have any questions.

Install freestanding oven and gas cooktop and must take away old one. *Location Marsden Park NSW 2765 Need to be licensed plumber and gas fitter

1. One of bath tub taps has come loose, need to repair/replace 2. Replace dishwasher pipe that releases dirty water 3. Help screw on pipe to a tap 4. Install bidets in 2 toilets

Hi, I need a 7kg clothes dryer wall mounted in the laundry, above the washing machine. The dryer will need to be securely installed on the wall with the correct brackets/fixings. Please bring the required tools and confirm if you can supply suitable brackets, or let me know what I need to purchase beforehand. Looking for someone experienced with dryer wall mounting and able to ensure it is safely secured.