Hire a trusted gas stove repair and installation service near you

I am after a Gas cooktop and Ranghood above it. I have pulled the dishwasher where the gas cooktop needs to be installed and the rangehood in cabinet above it. Installation needs to be done by certified professional. Sizes Gas Cooktop 600mm by 600 mm Vented Rangehood 600mm by 300mm that pulls out to 600mm. I have given example photos Offer to explicitly mention if they can supply and install or install only. Appliances need to be black colour if supplied or I can supply and quote install only. Gas meter is nearby approx 6m from this kitchenette.

I need to replace my current gas cooktop with a new one. The new one is slightly bigger than the old one. Current gas dimension 490mm * 570mm. Require a certified professional

Multiple burners not working on stove top

I just renovated my kitchen. In new kitchen cabinet my gas cooktop comes opposite of where the old cooktop was there. So I would like to extend the gas plumbing. It is a stump based property

The gas burner won’t ignite on its own. When I light it with a lighter, the flame stays on for about 2 minutes and then goes out. Pls see the image of stove model , brand

I need a gas cooktop installed. The benchtop cut-out is already done, and the existing gas connection is in place. It just needs to be connected. please send your quote. Licensed Plumber / Gasfitter

I need to replace an old gas cooktop. I have purchased a new cooktop and need it fitted by a qualified plumber/gasfitter and a compliance certificate issued.

We have currently 900mm Westinghouse 5 burner gas cooktop. This needs to be taken out and replace with the new 5 burner gas cooktop from EURO.

We would like to replace the 60cm 4 burner gas cooktop, with the new one. Dispose the old one. Due to regulation need to be installed by licensed to install gas cooktop and an invoice

I bought a 90cm ASKO gas stove. The hole in my bench is slightly too small, some stone needs to be cut and possibly a little timber. Also need to connect the gas. Hole dimensions 83.5cm x 47.5cm Stove base dimensions: 85cm x 47.6cm

## Licensed Gas Fitter Needed – Gas Cooktop Installation (Kogarah, NSW) I’m looking for a **licensed gas fitter with a valid NSW licence** to help install a new gas cooktop at my house in Kogarah. **Please do not apply if you do not hold the appropriate NSW gas-fitting licence.** **Preferred date:** Saturday, 17 October 2026, during the day after 12pm. **Parking:** Driveway parking available. ### Scope of Work 1. **Remove existing gas cooktop** – I can assist with removal and disposal. 2. **Install new gas cooktop** – Electrolux 60cm Natural Gas Ceramic Cooktop (Model: EHG635BE), already purchased. 3. **Enlarge existing benchtop cut-out** – The benchtop is laminate, and the existing cut-out needs to be enlarged slightly to accommodate the new cooktop. - New cut-out width: 560 mm - New cut-out depth: 490 mm I’m a qualified carpenter and can assist with the benchtop modification using a jigsaw and circular saw, if appropriate. 4. **Connect and safety-test the cooktop** – Complete the gas connection, installation and required safety testing. Existing gas and electrical outlets are available below the cooktop. ### About the Job I’m a qualified carpenter and happy to assist with suitable preparation and other tasks to help get the job done efficiently. **I don’t think the job will take too long**, especially as I can help with the removal and benchtop modification. All gas-fitting work must be completed by an appropriately licensed professional. Please get in touch if you hold the required NSW licence and are available on the preferred date. When responding, please confirm your licence, availability and quote for the job. Thank you!

I need the gas disconnect for an oven stove please see picture

The spring in the bathroom sink plug is no longer releasing. I pushed it down, but it is now unable to pop back up. The cooktop ignition is also not turning on, although the gas is still working.

Looking for an appropriately qualified/licensed appliance repairer or gas fitter to attend a short-term rental property in Windsor, Brisbane to diagnose and repair a gas cooktop ignition issue. Issue: - Gas is flowing to the burners normally - Burners are not electronically sparking/igniting - Guests can currently light the burners manually, but we need the ignition repaired - Make/model can be provided once confirmed We would like someone to attend as soon as possible this week, diagnose the fault and repair it where possible during the same attendance. Potential issue may relate to the ignition system, spark module, electrode or microswitch, however this will need to be professionally diagnosed. Please include in your offer: - Call-out/diagnostic fee - Your availability - Relevant licence/qualifications - Whether you can supply common replacement parts if required Please provide photos/details of the fault and completed repair for our property records.

I’m looking for a qualified and licensed gas fitter/plumber to replace my existing gas cooktop. The job involves: * Safely disconnecting and removing the existing gas cooktop * Installing and connecting the new gas cooktop * Ensuring everything is safely and correctly fitted and compliant * Removing/disposal of the old cooktop I’m looking for someone who is properly qualified and licensed to carry out gas work. Please include your total estimated price for the job when making an offer, including removal of the old cooktop if possible.

Remove existing Gas Cooktop and Install new Miele Gas Cooktop We believe the Cutout is the same size on existing granite bench top. Miele model: KM 362-1 G (https://www.thegoodguys.com.au/miele-59cm-4-burner-gas-cooktop-stainless-steel-km-362-1-g) Location is in St Kilda East/Balaclava

Looking for a licensed gas plumber/gasfitter to inspect and repair our gas cooktop. The burners are igniting normally while the control knob is pushed in, however the flame goes out as soon as the knob is released. This appears to be happening across multiple burners. Looking for someone to diagnose the issue and repair it if possible during the visit. Please include your call-out/labour cost and any likely additional costs for parts.

Gas cooktop not igniting as per photo , 1 not working can hear lighting sound, need to hold it for using. Need a repair

Licensed gas fitter needed to inspect/fix a 4-burner gas cooktop in Yarraville. One burner won’t stay lit and the other burners have inconsistent flame strength, particularly when several are used at once. Looking for diagnosis and repair.

Looking for a licensed plumber and gas fitter. All new appliances will be on site ready to install. Gas Cooktop: Disconnect old unit, install new cooktop into existing laminate benchtop. Dishwasher: Straight swap-out using existing under-sink plumbing and power socket. Fridge Water Line: Run a new cold water line to the fridge alcove (no current outlet at the fridge location in the kitchen, will need to be a brand-new line).