Find an experienced gas fitter in South East Melbourne

Fix my pilot gas light, turn on then off quite fast

Looking for a licensed gas fitter / gas plumber to complete a residential gas safety inspection and compliance check at my home in Hampton Park.

Gas safety check required for rental property in Cranbourne. Licensed gasfitter/gas plumber only

Need following attented and supplied with compliance certificate post completion. Address Wingate Avenue, mount waverly. Gas Line is in Galvanised Steel and during inspection Gas leak detected t property. eliminate gas leak however this is not a long term Gas Leak investigation to be conducted to try and solution due to the line being in galvanised steel. - Supply and Install New PTR Valve to Hot Water Unit PTR Drain needs relocating to safe location from hot water service to be compliant and safe. Secure Hot Water service for Safety to fixed wall Supply and install Thermal Insulation to PTR valve Cooktop GAS Regulator not in accessible location per regulations needs to be located Tempering Valve on Hot Water Service - To avoid scalding regulates water to maximum 50 degrees per VBA Regulations.

One of the gas burner is not staying on. Have to hold it for longer to keep-it on.

3 Burners (Gas) not working.

Gas safety check for 2 x townhouses that are located next to each other. A front garden tap also needs to be fixed/replaced as the tap handle comes off. Must be fully licensed and insured gasfitter (endorsed in the specialised class of Type A Gas Appliances Servicing - Gas Servicing Type A on the Plumbers Identity Card) and must provide official compliance certificates as per Victorian Residential Tenancies Regulations 2021

I want to install the kitchen equipments

Existing gas stove cooktop has been removed and replaced with electric system. Old gas piping need to be permanently capped

Hot plate pilot light ignition need to be replaced . It is moving freely and not doing any clicks to start pilot . Also need gas burner fix , not able to turn on pilot light on it , looks like not getting any gas supply in it.

One gas igniter does not work on my 4-burner gas cook top and it needs replacement. Currently we are lighting this one burner with matches. Simple and straight forward job.

I need a licensed gas fitter to replace an old gas heater with a new one. Existing heater: • Rinnai 2000T (old style gas heater – see photo) New heater (already purchased): • Rinnai Energysaver 559FT • Extension flue pipe: ESPIPE900 (already available) Scope of work: 1. Remove and disconnect existing Rinnai 2000T 2. Install new Rinnai Energysaver 559FT 3. Install flue using supplied ESPIPE900 4. Cut a round hole through brick wall for external flue 5. Connect gas, test and commission heater 6. Ensure installation is compliant and safe Important: • Brick wall penetration required (see photo) • Please confirm if additional flue parts or fittings are required • Quote must include all labour, tools, and minor materials • Must be a licensed gas fitter (Victoria) • Please confirm if compliance certificate will be provided • Optional: advise cost to remove/dispose old unit Please include in your reply: • Gas licence details • Experience with Rinnai Energysaver installation • Fixed total price • Availability

A sealed gas pipe is sticking out the wall after the wall heater was removed. We need to have a licensed plumber to have it shortened so we can patch the wall.

Hi everyone, I am looking for a licensed plumber or gas fitter to permanently disconnect and cap the gas line to my broken cooktop so I can safely have an electric induction unit installed later. My current setup is a standard 60cm gas cooktop sitting directly above a Westinghouse electric wall oven. The gas is currently turned off at the main valve and the benchtop is laminate. I need you to safely disconnect the broken gas cooktop and permanently cap the gas pipe behind the oven. You will also need to test the line to ensure there are absolutely no leaks and issue a VBA Gas Compliance Certificate, which is mandatory for me to proceed with the electrical stage. Please leave the decommissioned cooktop sitting in the benchtop cutout once disconnected. My electrician will remove and dispose of it later to ensure dust and debris do not fall into the exposed oven casing in the meantime. You do not need to do any physical removal or electrical work. Regarding availability, I work from home most days, so my schedule is highly flexible for you to drop by during the week. Cheers, Sean

I need a compliance check for gas + fixes needed if required. Quote is for compliance check and fixes will be separately managed as needed

Looking for someone who can safely remove an old gas heater from our wall. No need to patch the hole.

Will be demolishing my kitchen to renovate and need the gas line to the cook top capped off. I will be installing a freestanding one afterwards so there will be reconnection later.

Same size cooktop replacement gas Need certificate. Plumber needed

Service my gas burner and check gas line

Hi, I’m getting my kitchen renovated and I need a licensed plumber or gas fitter to connect my existing gas line to a new stove. The stove is already here and I have all the parts/pipes needed, just need someone who knows what they’re doing to hook it up properly and test it. Should be a straightforward job since the gas line is already there.